Results 1 to 3 of 3
Thread: Handloading For 7.7 x 58 mm Jap
-
September 28th, 2007, 02:24 AM #1
Handloading For 7.7 x 58 mm Jap
In need of Data!
Also, I've been reading that 30-06 Cases can be converted to 7.7 Jap.
Can this be true ?,
"the brass for this caliber is easily made from .30 ’06 brass. Chop off about a 1/4 inch, then run into the sizing die and trim to length."
Sounds to easy!
-
September 28th, 2007, 04:43 AM #2
Re: Handloading For 7.7 x 58 mm Jap
Lots of info over on "The Reloading Bulletin Board" (to much good info to cut and paste for you) it is a reloading forum, just put in 7.7 and search the "Rifle Cartridges" section...you will have a lot of reading to do!
Here: http://www.reloadbench.com/cgi-bin/u...assCookie=trueLast edited by 762xIan; September 28th, 2007 at 04:50 AM.
"Disperse you Rebels! Damn you! Throw down your Arms and Disperse!" British Major Pitcairn at Lexington April 19, 1775
"Sometimes reasonable men must do unreasonable things" Marvin Heemeyer
-
September 28th, 2007, 12:50 PM #3
Similar Threads
-
Handloading For RRA LAR 15 NM
By Lambo in forum GeneralReplies: 0Last Post: March 7th, 2007, 11:02 AM
Bookmarks