Pennsylvania Firearm Owners Association

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Welcome to the Pennsylvania Firearm Owners Association Forum, we hope you like what you find here and we strongly encourage you to register for an account with us, especially if you are from Pennsylvania. Once registered you will have access to participate in our community. Thanks for visiting and we hope you become a regular!
Attention! There has been an influx of scammer signups!

The method of operation is to private message you and tell you that you should contact such 'n such person at a given email address.

Please report the private messages. Staff will ban the offender, and I will implement an IP ban. Unfortunately these scammers are using VPN/proxy services, which may mean your VPN/proxy may be blocked.
Attention! About VPN's and foreign IP addresses.

When signing up, do so from a US based Internet Service Provider. Turn off any VPN/safe-browsing feature. Failure to do so will result with your new account denied.

If you run into a IP ban afterwards as a member, again - turn off your VPN or switch servers. We do not ban legit Internet Service Providers from the USA(exception for certain individual IP addresses). Free VPN's tend to get banned too. We try not to ban legit subscription VPN services, but they rarely label their IP blocks correctly.

If you run into an IP ban, it likely wasn't you.

Results 1 to 1 of 1

Thread: Marbles oddity?

Thread Tools
Display
- Linear Mode
- Switch to Hybrid Mode
- Switch to Threaded Mode

August 29th, 2009, 10:56 AM #1
TimmL

View Profile

View Forum Posts

Private Message

Junior Member
Join Date

Aug 2009

Location

Grand Rapids, Michigan

Posts

1

Rep Power

0
Marbles oddity?
Hello-I can't find mention of this set-up in my sights book or old Marbles, Brownells, Herter's catalogs. The sight has characteristics of series 60 rear sights, but the dovetail is 1/4 inch, (I'm only able to measure the gap on top of the base since the sight won't actually come off of the base). The sight slides side to side on the base, (3/8 inch dovetail on the base), and you tighten the screw when you have it adjusted where you want it. Anyone seen this guy before. Does it have an "official" name/application code? Regards.
Attached Images

sights 002.JPG (437.8 KB, 23 views)
Reply With Quote