Installing a Pearce Grip Extension...

[PA86]

Does anyone have directions or a video on how to do this?

Thanks.

[PA86]

Found info easily with a search.. however I have somehow managed to get the spring in the mag out of alignment apparently. I hope its fixeable.

[jerseytactical]

Does anyone have directions or a video on how to do this?

Thanks.

I have Pearce Grip +1 extensions on all of my Glock 36 magazines. It's quite simple. Carefully slide a flat blade screwdriver in between the seem of the plastic bottom of the magazine on the side, thus separating the plastic bottom from the magazine itself. Carefully work off the stock plastic part from the magazine. I would angle it in such a fashion, that when the spring pushes out the stock bottom, have it hit a pillow, or some cushioned device. You then take the plastic piece with the peg in it, and align it in the Pearce Grip bottom. Carefully position the spring, and gently slide the new bottom onto the magazine, allowing the spring to form in place once the Pearce bottom is fully seated. Once that happens, there is another small piece that you place into the gap, where it will cover the opening of the new bottom. It really isn't that complicated, and I know they do have some demos on You Tube, and Google. Good luck, and pay extra attention to that spring!!! Load and unload a few times to test it.