Results 1 to 4 of 4
Thread: Belding & Mull powder measure
-
May 10th, 2009, 09:08 PM #1Junior Member
- Join Date
- May 2009
- Location
-
Marietta,
Georgia
- Posts
- 2
- Rep Power
- 0
Belding & Mull powder measure
How do I stop the handle from separating from the linkage? When the handle is thrown to the right it tends to drop down with the weight of your hand, causing the post on the other end to come up out of the hole that connects it to the linkage arm. I am not a reloader yet but would like to get this one I inherited from my dad working. I've read that this measure is one of the best, but looks like bad engineering to me.
-
May 11th, 2009, 12:49 PM #2Super Member
- Join Date
- May 2008
- Location
-
Bellwood (Tyrone),
Pennsylvania
(Blair County) - Posts
- 604
- Rep Power
- 811564
Re: Belding & Mull powder measure
I’ve done a few of these and your comment about bad design is correct. The problem is that B&M used a non-standard shoulder bolt and a cross screw to hold the bolt in place. My normal fix is to ream (and sometimes bush) the pivot hole, install a new shoulder bolt, one that tightens completely, with one or two Belleville washers between the shoulder bolt head and the rotating plate.
Steve
-
May 11th, 2009, 02:50 PM #3Junior Member
- Join Date
- May 2009
- Location
-
Marietta,
Georgia
- Posts
- 2
- Rep Power
- 0
Re: Belding & Mull powder measure
Thanks for your help Steve.
Will give it a try and see what happens.
-
December 11th, 2009, 12:49 PM #4Junior Member
- Join Date
- Dec 2009
- Location
-
proctor,
Vermont
- Posts
- 6
- Rep Power
- 0
Re: Belding & Mull powder measure
If you are not up to modifuing it try the strongest Locktite. I use mine on BP and I just love it.
Similar Threads
-
BELDING AND MULL PHILLISPBURG PA
By PROVANTAGE in forum ShopsReplies: 9Last Post: January 14th, 2017, 11:31 AM -
Belding and Mull (Philipsburg, Pa)
By wryekid in forum GeneralReplies: 7Last Post: December 4th, 2009, 09:00 PM -
BELDING & MULL PHILIPSBURG, PA
By vmax82 in forum GeneralReplies: 34Last Post: July 21st, 2009, 07:50 AM -
Belding & Mull in Philipsburg
By Mity2 in forum GeneralReplies: 22Last Post: April 10th, 2009, 05:40 PM -
Need help with a powder measure
By rich in forum GeneralReplies: 12Last Post: July 30th, 2007, 01:15 PM
Bookmarks