Pennsylvania Firearm Owners Association

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Welcome to the Pennsylvania Firearm Owners Association Forum, we hope you like what you find here and we strongly encourage you to register for an account with us, especially if you are from Pennsylvania. Once registered you will have access to participate in our community. Thanks for visiting and we hope you become a regular!
Attention! There has been an influx of scammer signups!

The method of operation is to private message you and tell you that you should contact such 'n such person at a given email address.

Please report the private messages. Staff will ban the offender, and I will implement an IP ban. Unfortunately these scammers are using VPN/proxy services, which may mean your VPN/proxy may be blocked.
Attention! About VPN's and foreign IP addresses.

When signing up, do so from a US based Internet Service Provider. Turn off any VPN/safe-browsing feature. Failure to do so will result with your new account denied.

If you run into a IP ban afterwards as a member, again - turn off your VPN or switch servers. We do not ban legit Internet Service Providers from the USA(exception for certain individual IP addresses). Free VPN's tend to get banned too. We try not to ban legit subscription VPN services, but they rarely label their IP blocks correctly.

If you run into an IP ban, it likely wasn't you.

Results 1 to 1 of 1

Thread: Kel-Tec P-3AT

Thread Tools
Display
- Linear Mode
- Switch to Hybrid Mode
- Switch to Threaded Mode

March 19th, 2009, 05:49 PM #1
Enfielder

View Profile

View Forum Posts

Private Message

Senior Member
Join Date

Jan 2009

Location

Exton, Pennsylvania
(Chester County)

Posts

310

Rep Power

513194
Kel-Tec P-3AT

SOLD

WTS Kel-Tec P-3AT, black frame, blued slide. $250
My 1st (and last) mousegun. Bought Tuesday. 2 range sessions, 80 rounds through it. Too small for my hand; can't get a proper grip on it. When the grip feels right, 2nd joint of index finger works the trigger, doesn't feel right.
6 failures to feed in the 1st 50 rounds. Nose of bullet didn't make it up the feed ramp. KTOG.org suggested polishing the feed ramp.
Polished feed ramp only with DICO JR1 (jeweler's rouge) & White felt bob to remove obvious machining marks. See photo.
1 Failure to feed in next session, 5 mags of 6 rounds (yay).

FTF at an FFL. Chester or adjacent counties. Buyer pays fees (and can have the 20 remaining rounds of .380 Auto)

Last edited by Enfielder; March 22nd, 2009 at 04:37 PM.

Reply With Quote