Do lee full length dies deprime too?

[Kaos]

Do lee full length dies deprime too?

Simple question, pulling the trigger on some more reloading stuff today and need to clarify this before checking out.

[Bama Man]

Yes, generally.
I don't know about any special order dies,
But I have yet to see a Lee full length sizing die that did not have the decapping pin.
These decapper/expander pins can be replaced also, if you should happen to break the pin off.
This is easily done, if you should happen to try to decap a berdan case which I have done on several occasions.
CHECK YOUR BRASS FIRST!!!!!!!!!!!
I have two (2) 30-06 full length sizers that I need to replace the expander/decap pins on.
Lee sells the replacements for $3.00 each.

[Kaos]

Rep sent your way!

Just need to ask some relatives for dies as a gift.

[andrewjs18]

I use a manual base and decapper to deprime my brass...sure it's quick on a press, but you can't take your press into your living room and watch TV while doing it....well, you can, but I don't know many willing to do all that.

The decapper/base is like $4-5 and if it breaks, Lee will replace it for free...

[Kaos]

I use a manual base and decapper to deprime my brass...sure it's quick on a press, but you can't take your press into your living room and watch TV while doing it....well, you can, but I don't know many willing to do all that.

The decapper/base is like $4-5 and if it breaks, Lee will replace it for free...

picstures/links?

[rwilson452]

decapper and base


http://www.leeprecision.com/cgi/cata...l#DecappingDie

a press you can take into the living room

http://www.leeprecision.com/cgi/cata.../rlpress1.html

[fingers80002]

It's not just berdand primed that will break them, Stuck media will also.

You finger will not, it de-primes fingers very easily!!!!!!

[RJH245]

Lee sells the replacements for $3.00 each.

I broke a lee decaping pin on .30-06 brass and lee did send me a replacment for free. It was boxer primed brass with an off center flash hole

[Don T.]

The decapping pins on Lee full length sizer dies are collet mounted. If you hit media, or a Berdan primed case, they just rise into the die. Use a 1/2" and a 3/4" wrench, loosen collet, reset decapping pin, and continue resizing. They won't break.

[fingers80002]

Yes, generally.
I don't know about any special order dies,
But I have yet to see a Lee full length sizing die that did not have the decapping pin.
These decapper/expander pins can be replaced also, if you should happen to break the pin off.
This is easily done, if you should happen to try to decap a berdan case which I have done on several occasions.
CHECK YOUR BRASS FIRST!!!!!!!!!!!
I have two (2) 30-06 full length sizers that I need to replace the expander/decap pins on.
Lee sells the replacements for $3.00 each.

I'm glad I use lyman and RCBS!!!!!!
Decap pins are .30 each!!!!