Another Heritage Arms question

[TKY]

I've seen other posts about the Heritage Arms Heritage Rough Rider .22; my issue seems to be a bit different and I hop in the intervening time someone may have found a solution. I have a Heritage Arms Heritage Rough Rider .22 with two cylinders a .22LR and a .22WMR. The handgun works great with the .22LR cylinder. When I install the .22WMR cylinder I have serious problems. I can get the cylinder installed, but I can only pull the hammer back to the half cocked position. I cannot bring the hammer back to a fully cocked position. When I bring the hammer back to the half-cocked position it does not rotate the cylinder to the next chamber position. Anyone have any thoughts on a solution?

Thanks, Terry

[Rural Ruger]

Sounds like the cylinder could be slightly out of spec. Could ask if they'd take a look at it, possibly get a new cylinder. Not familiar with their warranty program but most manufacturers are decent to work with. Even Taurus.

[jthrelf]

Give them a call, get a prepaid label to send the cylinder in, hopefully get shipped a replacement. That would be ideal.