Stock and pistol grip loose on Beretta 1301

[Will3212]

I put about 50 rounds of slugs through my Beretta 1301 tactical at the SGL range today.
When I got home I noticed the 1 piece stock and pistol grip was crooked.
It's loose, like I can rotate it left and right.
Anyone know how to tighten this?
Thanks in advance.

[RockIsland]

Take off the recoil pad and tighten the stock bolt. It should be 13mm.

[Will3212]

Take off the recoil pad and tighten the stock bolt. It should be 13mm.

Thanks, do you recommend lok tite?

Also, is there a recommended torque number?

[RockIsland]

Thanks, do you recommend lok tite?

Also, is there a recommended torque number?

Some Lok-tite wouldn't hurt unless you plan to remove it any time soon.

There probably is but I usually go by "Tight is tight, and too tight is broken".

I wouldn't go more than 10 ff/lbs.

[Will3212]

Thanks again, do you know the torx bit size for the scope rail screws? I tightened them with a hex bit and the screws stripped on the surface. These screws also have a torx star pattern deeper in the screw. It's hex on the surface then torx beneath the hex if that makes sense.

[smit308]

for under $15 you can get a whole set from amazon. https://www.amazon.com/Amartisan-24-...ps%2C95&sr=8-6

or if you want to cheap it out you can get a set from harbor freight for $5 https://www.harborfreight.com/securi...hoCMmcQAvD_BwE

Smit

[Bang]

Or 100 piece security set from Harbor Freight for $12

https://www.harborfreight.com/media/.../8/68457_I.jpg