Where locally to get a 365 slide cut for optic.

[bripro]

I’m in Lancaster. Would like to keep it local. I haven’t had good luck finding a known place to put an optic cut in a standard slide. If anyone suggestions I’m all ears. Thank you.

[jthrelf]

I know this is a super annoying type of response that answers a different question than asked... But here we go....

I'd buy a P365X and sell off the parts not used on SigTalk which would be: your original upper, one of the FCUs, one of the grip modules and maybe mags if you want. You'll make your money back give or take (with a bit of effort, admittedly) vs. paying about $1-200 for a non-factory cut & refinish.