Pennsylvania Firearm Owners Association

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Welcome to the Pennsylvania Firearm Owners Association Forum, we hope you like what you find here and we strongly encourage you to register for an account with us, especially if you are from Pennsylvania. Once registered you will have access to participate in our community. Thanks for visiting and we hope you become a regular!
Attention! There has been an influx of scammer signups!

The method of operation is to private message you and tell you that you should contact such 'n such person at a given email address.

Please report the private messages. Staff will ban the offender, and I will implement an IP ban. Unfortunately these scammers are using VPN/proxy services, which may mean your VPN/proxy may be blocked.
Attention! About VPN's and foreign IP addresses.

When signing up, do so from a US based Internet Service Provider. Turn off any VPN/safe-browsing feature. Failure to do so will result with your new account denied.

If you run into a IP ban afterwards as a member, again - turn off your VPN or switch servers. We do not ban legit Internet Service Providers from the USA(exception for certain individual IP addresses). Free VPN's tend to get banned too. We try not to ban legit subscription VPN services, but they rarely label their IP blocks correctly.

If you run into an IP ban, it likely wasn't you.

Results 1 to 10 of 20

Thread: What do I need to do to build an AR pistol on existing or new stripped receiver?

Thread Tools
Display
- Switch to Linear Mode
- Switch to Hybrid Mode
- Threaded Mode

Threaded View

January 24th, 2023, 09:38 AM #9
ExFlyinguy

View Profile

View Forum Posts

Private Message

Grand Member
Join Date

Mar 2014

Location

NEPA, Pennsylvania
(Wyoming County)

Posts

2,320

Rep Power

21474849
Re: What do I need to do to build an AR pistol on existing or new stripped receiver?

I'm going to be a contrarian. Personally I would feel just fine building a pistol MINUS a brace.

Use a "Pistol buffer tube"

"It seems that the Constitution is more or less guidelines than actual rules"
My feedback: http://forum.pafoa.org/showthread.php?t=305685

Reply With Quote