Results 1 to 8 of 8
Threaded View
-
October 12th, 2021, 08:20 PM #1
Need help w/ FRT install on my S&W AR
Installed an Rare Breed FRT trigger in my S&W AR.
Had to swap out the factory BCG & replace it with a full auto M16 BCG.
Everything went together perfectly. The trigger absolutely rocks.
HOWEVER:
After disassembling for cleaning, the upper & lower refuse to close.
There's a ⅛" gap between the two receivers at the rear takedown pin location.
When I first installed the new trigger setup, I think I was able to push the bolt itself into the carrier assembly. That allowed enough clearance for the 2 receivers to close properly.
Repeating that act doesn't seem possible now.
I'm open to everyone's input & advice.
AND:
For those who have yet to try one of the new FRT triggers (Rare Breed or Big Daddy's Wide Open Trigger), do yourself a favor, get one while you still can !"Mongo just pawn in game of life"
Similar Threads
-
20 MOA base install
By Marcus99 in forum OpticsReplies: 4Last Post: June 30th, 2017, 09:15 AM -
[Where?] Bucks County: PPQ - Dawson site install and Tavor Lightning Bow install
By Cole in forum GunsmithingReplies: 3Last Post: February 27th, 2016, 02:49 PM -
RMR install on Glock
By sprint51 in forum GunsmithingReplies: 3Last Post: July 15th, 2015, 10:02 AM -
ar-15 need somebody to help with barrel install
By aschwabe in forum GunsmithingReplies: 4Last Post: March 17th, 2015, 09:36 PM -
AK Barrel install
By 2muchstuff in forum GunsmithingReplies: 0Last Post: July 19th, 2014, 11:48 PM
Bookmarks