Results 1 to 10 of 16
Threaded View
-
February 20th, 2021, 01:20 PM #3Super Member
- Join Date
- Jun 2012
- Location
-
Honesdale,
Pennsylvania
(Wayne County) - Posts
- 694
- Rep Power
- 2990182
Re: Polymer 80 glock end plate installation
I think the firing pin safety plunger was the problem. Before when I had the extractor spring/rod, firing pin assembly installed with the end plate over both, the firing pin safety plunger wasnt moving at all it was binding/stuck. End plate wouldnt go in.
I re adjusted the extractor, where the firing pin safety plunger can move up and down when pressing. Then the end plate slid right in.
Similar Threads
-
Polymer 80 Glock build
By solrac7 in forum PistolsReplies: 18Last Post: February 12th, 2019, 11:54 AM -
Glock sight installation in Blair county??
By Squatchy in forum PistolsReplies: 3Last Post: June 1st, 2015, 09:03 PM -
Glock Sight Installation!
By Everlastingfate in forum GunsmithingReplies: 27Last Post: November 10th, 2013, 12:50 PM -
Glock nightsight installation in South East PA?
By Kb! Bob in forum GeneralReplies: 11Last Post: December 28th, 2009, 02:12 PM
Bookmarks