JSD Supply in PA Polymer80

[Royinmontco]

I wish I had a an actual Glock as a reference, but I don't. The picture below is taken through the barrel "bushing" in the slide. The first "protrusion" that you can see sticking up is the slide "pusher" (the thing that pushes the new round into the chamber). Immediately behind it is the firing pin sear. See how it's tilted over to the left? Could this be the issue with my firing pin sear? Also notice, that the slot that the sear rides along is also closer to the left side (it's offset by .015"). Anybody have access to semi-decent glock dimensional drawings?

I may have to move this one to the gunsmithing forum.

20210117_171939.jpg

[Royinmontco]

So many issues with this build, so I'm moving my discussion to it's own thread:
https://forum.pafoa.org/showthread.php?t=370071