Results 1 to 7 of 7
-
June 27th, 2020, 02:02 PM #1
Hold-open follower causing problem in AK mag?
Bought and installed three hold-open followers. Yesterday, firing my WASR 10/63, I was getting bullet tip jam at the bottom ledge of the ramp (Wolf Military Classic 124gr). The mag is an eastern bloc make that never gave feed problems before. Posting as an ask and as info if anyone is contemplating purchasing the followers (3 for $20).
There are two kinds of guns. Those I have acquired, and those I hope to.
-
June 27th, 2020, 02:46 PM #2
Re: Hold-open follower causing problem in AK mag?
Do the other half of the experiment and put the original followers back in the mags and test fire.
NoahWisdom and knowledge shall be the stability of thy times.
-
June 27th, 2020, 08:49 PM #3
Re: Hold-open follower causing problem in AK mag?
Lol...already replaced. Range trial next week.
There are two kinds of guns. Those I have acquired, and those I hope to.
-
June 27th, 2020, 09:04 PM #4
Re: Hold-open follower causing problem in AK mag?
If those are the primary arms/weapon tech BHO followers I have many and never an issue. If I remember correctly they are exactly the same dimensions as the Yugoslavian BHO followers.
-
June 27th, 2020, 09:27 PM #5
Re: Hold-open follower causing problem in AK mag?
Is there a chance the spring was installed backwards?
NoahWisdom and knowledge shall be the stability of thy times.
-
June 27th, 2020, 10:55 PM #6
Re: Hold-open follower causing problem in AK mag?
Is there a chance the spring was installed backwards?
Noah
I guard against that happening. I looked for it when I took it apart, and can say no. Upper and lower cut-offs face foreward.There are two kinds of guns. Those I have acquired, and those I hope to.
-
June 30th, 2020, 09:45 AM #7
Re: Hold-open follower causing problem in AK mag?
No feed problems from the Hungarian mag after changing back to stock lifter. Out of curiosity I had installed a bolt stop lifter in a grey Korean mag, and it too ran fine. I have a Hungarian that I've physically cut down to ten rounds and it's been good with a bolt stop. Guess there is something about that one mag that didn't like the bolt-stopping follower.
There are two kinds of guns. Those I have acquired, and those I hope to.
Similar Threads
-
Yugo bolt hold open AK mag going for $39.95???
By steel6whiskey in forum RiflesReplies: 2Last Post: January 8th, 2013, 02:05 PM -
Ruger 10/22 bolt hold open question...
By steel6whiskey in forum RiflesReplies: 5Last Post: May 22nd, 2012, 09:36 AM -
AK47 Bolt Hold Open follower + modified safety lever
By Dochartaigh in forum RiflesReplies: 4Last Post: May 14th, 2012, 10:43 AM -
AK Bolt Hold Open (a real one)
By Jackal in forum GeneralReplies: 11Last Post: December 11th, 2008, 06:00 PM -
AR-15 bolt hold open issue
By Kaos in forum GeneralReplies: 37Last Post: October 4th, 2008, 12:18 AM
Bookmarks