Pennsylvania Firearm Owners Association
Results 1 to 2 of 2
  1. #1
    Join Date
    Apr 2007
    Location
    Philadelphia, Pennsylvania
    (Philadelphia County)
    Posts
    35
    Rep Power
    0

    Default Milling a Hellcat slide

    So... I recently picked up a Springfield Hellcat. I bought it because I found a great deal. However, it was the non-optics ready model. It was the only model they had at the time and it was going to be a while before they got more in. So Now that I have decided that I want to put a red dot on it, I contacted Springfield to see if I could just purchase the optic ready slide. I cannot!!! So can any one recommend someone near the philadelphia area who can be trusted to mill and drill the slide?
    Glock 23
    Ruger SR9

  2. #2
    Join Date
    Aug 2011
    Location
    Allentown, Pennsylvania
    (Lehigh County)
    Posts
    196
    Rep Power
    674685

    Default Re: Milling a Hellcat slide

    It's just a slide so restrictions on dropping it in the mail (insured of course) to use and out of state gunsmith is no big deal. No FFL required.

    I would look for a shop that specifically does Springfield slides. They will be most knowledgeable about what the in's and out's are of doing one.

Similar Threads

  1. Slide milling recommendations?
    By daddy in forum General
    Replies: 3
    Last Post: March 10th, 2019, 08:14 PM
  2. Slide milling in Bucks County
    By MnPNewbie in forum Gunsmithing
    Replies: 1
    Last Post: June 22nd, 2018, 09:02 PM
  3. Glock slide milling in Delaware County
    By LunkTheHunk in forum Gunsmithing
    Replies: 0
    Last Post: July 26th, 2017, 06:43 PM
  4. Hellcat 380
    By knight0334 in forum Pistols
    Replies: 11
    Last Post: May 20th, 2011, 07:42 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •