Results 1 to 4 of 4
Thread: S&A model 10-11
-
April 13th, 2020, 04:07 PM #1Junior Member
- Join Date
- Aug 2015
- Location
-
mt bethel,
Pennsylvania
(Northampton County) - Posts
- 10
- Rep Power
- 0
S&A model 10-11
Can anyone tell me what year the S&W 38 spl. model 10-11 was made?
-
April 13th, 2020, 04:22 PM #2
Re: S&A model 10-11
From a quick web search:
Model 10 Variants S&W
Model Year Modifications
10 1957 Introduction
10-1 1959 Heavy barrel introduced
10-2 1961 Change extractor rod thread for standard barrel
10-3 1961 Change extractor rod thread for heavy barrel, change front sight width from 1/10" to 1/8"
10-4 1962 Eliminate trigger-guard screw on standard barrel frame
10-5 1962 Change sight width from 1/10" to 1/8" on standard barrel
10-6 1962 Eliminate trigger-guard screw on heavy-barrel frame
10-7 1977 Change gas ring from yoke to cylinder for standard barrel
10-8 1977 Change gas ring from yoke to cylinder for heavy barrel
10-9 1988 Replace yoke retention system, radius stud package, floating hand hammer nose bushing for standard barrel
10-10 1988 Replace yoke retention system, radius stud package, floating hand hammer nose bushing for heavy barrel
10-11 1997 MIM hammer/trigger and floating firing pin for standard barrel and HB heavy barrel Model M10 Park police model.
10-12 1997 MIM hammer/trigger + floating firing pin for heavy barrel
10-13 2002 Limited production 1899 commemorative edition
10-14 2002 Internal lock added
10-14 2010 Discontinued
10-14 2012 Reintroduced as part of the Classic Line
Edit: have a 10-10 myself. Police trade in. Looked rough but mechanically good. Main carry piece when working around the place.Last edited by cephas; April 13th, 2020 at 04:32 PM.
It ain't what they call you, it's what you answer to.
-
April 13th, 2020, 04:32 PM #3Senior Member
- Join Date
- Nov 2010
- Location
-
Drexel Hill,
Pennsylvania
(Delaware County) - Posts
- 396
- Rep Power
- 13066522
Re: S&A model 10-11
edskyy, The S&W Model 10-11 was first produced in 1997 and ran at least until 2001. The -11 engineering change included a different frame that eliminated the cylinder stop stud (as the frame now included in integral lug). This model also introduced the floating firing pin and MIM (metal injected molded rather than forged) hammer.
This is a pre-internal lock K frame which a lot a "true" S&W guys prefer.
If you would like a closer ship date(Smith & Wesson only recorded ship dates and not build dates) we'll need the Serial Number which should be inside the yoke when you open the cylinder or on stamped into the buttstock(depending on the grips you have you'll probably need to remove them to see it)
I hope this helps,
FYI, we like pictures too so if you would like post a few.
Regards,
KobswLast edited by kobsw; April 13th, 2020 at 04:36 PM.
-
April 13th, 2020, 04:39 PM #4Junior Member
- Join Date
- Aug 2015
- Location
-
mt bethel,
Pennsylvania
(Northampton County) - Posts
- 10
- Rep Power
- 0
Re: S&A model 10-11
Thanks for the info. If I knew how to post pics, I would.
Bookmarks