Pennsylvania Firearm Owners Association

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Welcome to the Pennsylvania Firearm Owners Association Forum, we hope you like what you find here and we strongly encourage you to register for an account with us, especially if you are from Pennsylvania. Once registered you will have access to participate in our community. Thanks for visiting and we hope you become a regular!
Attention! There has been an influx of scammer signups!

The method of operation is to private message you and tell you that you should contact such 'n such person at a given email address.

Please report the private messages. Staff will ban the offender, and I will implement an IP ban. Unfortunately these scammers are using VPN/proxy services, which may mean your VPN/proxy may be blocked.
Attention! About VPN's and foreign IP addresses.

When signing up, do so from a US based Internet Service Provider. Turn off any VPN/safe-browsing feature. Failure to do so will result with your new account denied.

If you run into a IP ban afterwards as a member, again - turn off your VPN or switch servers. We do not ban legit Internet Service Providers from the USA(exception for certain individual IP addresses). Free VPN's tend to get banned too. We try not to ban legit subscription VPN services, but they rarely label their IP blocks correctly.

If you run into an IP ban, it likely wasn't you.

Results 1 to 10 of 185

Thread: Baofeng UV5army

Thread Tools
Display
- Switch to Linear Mode
- Switch to Hybrid Mode
- Threaded Mode

Threaded View

May 21st, 2020, 01:22 PM #11
Sparks

View Profile

View Forum Posts

Private Message

Grand Member
Join Date

Feb 2011

Location

Phila, Pennsylvania
(Philadelphia County)

Posts

1,094

Rep Power

21474851
Re: Baofeng UV5army

Originally Posted by PA86

Ok, so I tried messing around to program a repeater.

My question is, now when I am in frequency mode, on ANY frequency, I see a "+" above the frequency. It seems I have saved the positive offset onto ALL frequencies. Is that so? If yes, how do I correct this so it only applies to the repeater frequency I was trying to program?

Thanks all for the help.

You just saved the positive offset into the one memory channel you programmed. However offset is turned on in VFO mode. You can turn it off there and not effect any stored frequencies.

Corruptissima re publica plurimae leges

Reply With Quote