Lee Pro Auto Disc Modification

[Gunowner99]

Can anyone point me to where I read this or give me advice? Setting up my Pro Auto Disc and I remember someone saying to sand some spots of the discs and coat some surfaces with graphite? This make sense? I can't find my notes now unfortunately. I have very very fine grit and sandpaper and some graphite powder but no notes. Thanks!

[2Late45]

http://www.taurusarmed.net/forums/re...harge-bar.html
If the link works it may be what you're referring to.

[Gunowner99]

Maybe I'll just stick with my drum because I'm like to mess that up ha ha!

[dkf]

I never sanded mine any or coated anything with graphite. Main thing I did was wash all the parts with dish soap and let them dry completely. Then ran over everything well with a drier sheet to remove the as much static as possible and then run powder through it. The parts will blacken up some from use and work better.

A mod you can do to make fine adjustments on the discs is add a set screw. Drill and tap the cavity for a set screw. You can turn the set screw in or out to adjust the charge. The adj charge bar is known for not being consistent.

[Gunowner99]

Thanks for the response. I guess I will clean and let dry and see how it works before I go messing up anything!