Results 1 to 10 of 14
-
September 21st, 2016, 06:05 PM #1
I want to convert my traditions Flintlock to a percussion
Does anyone know if they make a kit that can turn a Traditions Flintlock into a percussion model. I would think this would be a simpler job then percussion to Flintlock. I was just wondering if anyone knew of a kit?
Praise the Lord and pass the ammunition
-
September 22nd, 2016, 09:31 AM #2
Re: I want to convert my traditions Flintlock to a percussion
No kit, but it could be done. Probably not worth the cost to do so. I assume you want to hunt both seasons with the same rifle?
Toujours prêt
-
September 22nd, 2016, 01:46 PM #3
-
September 22nd, 2016, 02:19 PM #4
Re: I want to convert my traditions Flintlock to a percussion
Replacing the lock mechanism would be easy enough.
The tricky part would be the nipple for the percussion cap. That is part of the barrel. I suppose you could have the touch hole drilled out and threaded to screw in a nipple but it would be aligned in the wrong direction for a hammer. The hammer is gong to be parallel to the barrel but the touch hole is horizontal to the barrel.
-
September 22nd, 2016, 02:19 PM #5
Re: I want to convert my traditions Flintlock to a percussion
I've been doing a bit of research cheaper just to get an inline I guess.
-
September 22nd, 2016, 02:24 PM #6
Re: I want to convert my traditions Flintlock to a percussion
The touch hole is already threaded for a touch hole liner. The old time conversions I've seen have a cylinder screwed into the touch hole and a nipple coming out of the side of a cylinder to face the hammer. But I don't know if the touch hole threads would be strong enough for this or I would have to drill and rethread making the process irreversible.
-
September 22nd, 2016, 02:28 PM #7
Re: I want to convert my traditions Flintlock to a percussion
I was kinda hoping someone made a kit with a lock and a cylinder that would screw into the touch-hole ideally the new lock would have some sort of support for the cylinder where the flash pan used to be. Apparently I need to design one LOL
-
September 22nd, 2016, 03:20 PM #8
Re: I want to convert my traditions Flintlock to a percussion
Or...
Build one of these.
http://kirbos.net/ar_smoke_pole/Soap Box - Worn out : Ballot Box - Broken : Jury Box - Pending : Ammunition Box - Unknown
-
September 23rd, 2016, 06:39 AM #9
-
September 23rd, 2016, 07:16 AM #10
Re: I want to convert my traditions Flintlock to a percussion
Because Failure Is Not An Option
Bookmarks