Results 1 to 2 of 2
-
February 13th, 2016, 06:40 PM #1
Need help from you kydex holster makers
I just picked up a Kydex on the waist holster for a Glock 27. It's molded at the end of the muzzle and wraps around it about a quarter inch on all sides. I would like to open it up so I could use the same holster for my model 19 and 17. Is there a way to do it without cutting off material? Can I heat it and bend it out word without risking losing the mold of the pistol? As always any suggestions are greatly appreciated, Brian.
Last edited by bripro; February 13th, 2016 at 08:55 PM.
DDG-8 "Sine Timore"
-
February 13th, 2016, 06:47 PM #2
Re: Need help from you kydex holster makers
Slowly heat the area you want to remold with a heat gun or blow dryer (if you have one that get's that hot) and remold it. For a better finished product find a wooden dowel that is the same height as your front sight and tape it to the top of the slide then insert the pistol while heating the area and reshape it around the top of the dowel.
Similar Threads
-
Crossbreed goes after hybrid holster makers
By middlefinger in forum GeneralReplies: 10Last Post: November 8th, 2014, 10:47 PM -
custom leather holster makers near the lehigh valley?
By General Geoff in forum Concealed & Open CarryReplies: 3Last Post: August 2nd, 2013, 10:48 AM -
Help - Harrisburg Area Holster Makers???
By twhman in forum GeneralReplies: 6Last Post: December 26th, 2012, 12:04 PM -
any custom holster makers in PA who can make...
By Ten*K in forum GeneralReplies: 7Last Post: September 20th, 2008, 01:56 PM -
Holster makers you like
By luckyned7 in forum GeneralReplies: 20Last Post: June 16th, 2007, 07:45 AM
Bookmarks