Glock Factory Sights

**Solaran_X** · June 9th, 2014, 08:44 PM

Is there any market for these?

I just put some Trijicon Bright and Tough night sights (with the Novak rear) on my Glock 17, and will likely be putting them on my Glock 21 as well. So right now I have a spare set of factory Glock sights from the 17 and will have a set from the 21 as well in the near future.

**animalmother85** · June 9th, 2014, 08:47 PM

Originally Posted by Solaran_X

Is there any market for these?

No.

**IronButt** · June 9th, 2014, 08:50 PM

Originally Posted by Solaran_X

Is there any market for these?

I just put some Trijicon Bright and Tough night sights (with the Novak rear) on my Glock 17, and will likely be putting them on my Glock 21 as well. So right now I have a spare set of factory Glock sights from the 17 and will have a set from the 21 as well in the near future.

I can't think of a market for them. Glock just installs them to keep dirt out of the rear dovetail & the front sight hole until the owner can buy a set of real sights.

**jthrelf** · June 10th, 2014, 07:33 AM

I don't mind the glock factory sights but yes they're essentially worthless

***Klutch*** · June 10th, 2014, 07:45 AM

I could use a set of them for a 9mm if you wouldn't mind getting rid of them, please let me know

**TheRealDonJohnson** · June 10th, 2014, 10:36 AM

Over the years I've learned that it doesnt hurt to have some extra on hand. Might as well hang on to them. For what youd make selling them you would waste on shipping. :/

**bripro** · June 10th, 2014, 05:42 PM

I'm not sure about the Gen 4s but the only way to get the front sight off the earlier ones is to break it.

***Klutch*** · June 10th, 2014, 05:49 PM

Originally Posted by bripro

I'm not sure about the Gen 4s but the only way to get the front sight off the earlier ones is to break it.

This isn't true. The front sight is split underneath and has a small pin in it that spreads the two halves. They can be reused.

**Brick** · June 10th, 2014, 07:10 PM

Originally Posted by bripro

I'm not sure about the Gen 4s but the only way to get the front sight off the earlier ones is to break it.

That's odd mine (Mod 19 gen 2) had a small hex nut that was easy to remove with a small tool purchased from Midway.

There are other versions available but here's one:
http://www.midwayusa.com/product/844...ck-to-top-link