Busy weekend reloading

[lethal93ta]

well since it was so hot out I decided to sit inside and load some ammo that Ive been getting behind on, between yesterday and today I loaded 1000 .223, 1100 9mm, and 200 .45ACP I still have about another 1000 .223 sitting here that the brass is ready to go I just need to load in the press, but that was enough for this weekend, I feel like I actually got something done for once.

[RUDY850]

Way to go looking good.I haven't reloaded in a month or so. I keep getting side tracked on buying the primers and dies that I need. I have plenty of brass and bullets and some powder.

I got a gun on layaway

2 AR' s to get parts for and put to gather

A 10/22 I need to finish

O and more brass and bullets to get

[lethal93ta]

Way to go looking good.I haven't reloaded in a month or so. I keep getting side tracked on buying the primers and dies that I need. I have plenty of brass and bullets and some powder.

I got a gun on layaway

2 AR' s to get parts for and put to gather

A 10/22 I need to finish

O and more brass and bullets to get

I know the feeling, I have 2 other AR lowers Im in the middle of building, one dont have anything in it yet, the other one I have a rock river trigger in there, a rock river A3 upper with a chrome carrier, the ACE ARFX buttstock is on the way, so I just need a barrel and hand guards for that one, Im looking at the JP barrel kits I think thats what Im going to order for it, its over 500 for a kit but man are they nice, and I want to get there handguard kit to. I just bought the XD45 that I didnt expect to get I just found a deal on it. and I just picked up a new dillon scales today since my lee was acting a little funny I didnt trust it anymore.

[andrewjs18]

nice...wanna come load at my G/F's house? LOL Her Dad must have over 10,000 empty casings of 9mm and I'm sure thousands of .223 casings. I think he also has .38, .357 .308 and some .45...I gotta go through them because I'm sure there's someone wanting some once fired .45 brass..it's probably de-primed and cleaned too.

[Kaos]

I want to start reloading very badly...

Though I have no hardware and no brass.

.223 and 9mm is where I want to start...I think one of the basic kits will get me started, but I think I need something that will clamp onto a table/desk since I don't have room for a workbench where I live now.

[smitty56]

Now that's and impressive weekend. I have a Dillon 650 setup for 45 and I reload such volume when I reload that when I need to again, I have just about forgotten about how it works.....

[Koli01]

I want to start reloading very badly...

Though I have no hardware and no brass.

.223 and 9mm is where I want to start...I think one of the basic kits will get me started, but I think I need something that will clamp onto a table/desk since I don't have room for a workbench where I live now.

I bolt my presses to a board. I can then c-clamp it to any table.

[XD45]

gotta love progressive press's, i've got the same one. you can knock'em out.