Results 21 to 22 of 22
-
December 16th, 2013, 06:39 PM #21Junior Member
- Join Date
- Mar 2012
- Location
-
Perkasie,
Pennsylvania
(Bucks County) - Posts
- 22
- Rep Power
- 0
Re: Problem with a new purchase from Phoenix
A quick update, I got the new spring and extractor to day, with the new extractor and spring I got two shoots off before a FTE. I then put the old spring on top the new spring and all six rounds fired without an issue. I only tested with the Federal rounds, when I can get out in daylight I will try the Blazer again. A longer screw was suggested by someone as the spring screw, doesn't seem to be a problem, the firing pin is retained both direction by the spring screw.
Donald A. Jones
-
December 21st, 2013, 06:30 PM #22Junior Member
- Join Date
- Mar 2012
- Location
-
Perkasie,
Pennsylvania
(Bucks County) - Posts
- 22
- Rep Power
- 0
Re: Problem with a new purchase from Phoenix
Okay I got two mag loads fired, one all Blazer and one 6+1 with Blazer and Federal alternating...all fired no issues. Now I need to use a target and practice aiming the gun. I have been firing at a steel target with no luck at 25 feet just firing off the hip(not using the sights) BTW only using one hand while shooting.
Donald A. Jones
Similar Threads
-
Got called a "jerk off" today
By JLBIII in forum GeneralReplies: 35Last Post: December 7th, 2013, 08:24 PM
Bookmarks