Results 1 to 5 of 5
-
July 5th, 2013, 11:44 AM #1
Quick question about MecGar plus two (or 3) base pads.
I'm embarassed to ask but how the heck do you get them off? To save some face, I bought a few mags with them pre installed so I didn't put them on. Thanks, Brian
DDG-8 "Sine Timore"
-
July 5th, 2013, 04:11 PM #2Grand Member
- Join Date
- Dec 2010
- Location
-
back to Port Charlotte,
Florida
- Age
- 60
- Posts
- 5,483
- Rep Power
- 3627622
Re: Quick question about MecGar plus two (or 3) base pads.
BCM and Glock...for a bigger pile of 'cold dead hands' brass.
-
July 6th, 2013, 12:12 AM #3
Re: Quick question about MecGar plus two (or 3) base pads.
Got them......thx.
DDG-8 "Sine Timore"
-
July 7th, 2013, 02:32 PM #4Active Member
- Join Date
- Apr 2012
- Location
-
Southwestern PA,
Pennsylvania
(Greene County) - Posts
- 226
- Rep Power
- 5195
Re: Quick question about MecGar plus two (or 3) base pads.
I had the same issue earlier this week, except I was installing them.. They're very different than traditional base pads.. There's a small metal plate that's above the base pad, which you can see at the back of the base pad.. Lift up on the metal plate and push the base pad right off, it's actually quite easy once you figure out how they work.. I guess they made them that way so they'll fit several different types of magazines.. I know they'll fit CZ 75's, Sig 226's, Beretta 92's, and also supposedly they fit M&P's, but they're not made for them
-
July 7th, 2013, 02:33 PM #5Active Member
- Join Date
- Apr 2012
- Location
-
Southwestern PA,
Pennsylvania
(Greene County) - Posts
- 226
- Rep Power
- 5195
Similar Threads
-
Quick-release rings/base - which ones?
By galvanni in forum OpticsReplies: 0Last Post: February 25th, 2013, 08:05 AM -
scope ring/base question
By .Kramer in forum GunsmithingReplies: 1Last Post: November 26th, 2010, 08:40 PM
Bookmarks