Did you go shooting today (Pic thread)

[27hand]

After 9 weeks of rehabbing this knee, I think I can finally get to the range.
I've loaded some .300 winmags with Berger 190s and some 180 accubonds ( both with H100v ), some .308s with Sierra gamechangers in 180 starting into my last couple pounds of 4064.

I try to take my AR22 and use up some old stock.

2021-05-09_08-35-51 by poofy27, on Flickr

Hope I don't need hip waders to get to the 100 and 200.

Today was a great day to go shooting.
2021-05-10_04-13-48 by poofy27, on Flickr

I took the Tikka although the 190 gr Berger loads with RL25 were 2 to 3 inch at 100.
I did load 6 180 gr accubonds and a mid charge of H100v and got minute of angle at 100 abd just over at 200.
I believe I'll load more Bergers with 100v and reload some additional accubonds too.

The .308 PA10 is close to 1" at 100 and opens up a bit at 200 using Sierra Gamechanger 180's and IMR4064
I was working this load as a hunting load for whenever Pa decides its OK to shoot a deer with a semi. I'm close to being satisfied out to 200 with it.

2021-05-10_04-25-41 by poofy27, on Flickr

Great day. One shooter finished as I got there. another shooter came when I finished. Range to myself is always cool beans.

[scruff]

I just popped into the .22 rimfire range at PMSC today. Every single plate rack still works!

[Jhaydeno]

After 9 weeks of rehabbing this knee, I think I can finally get to the range.
I've loaded some .300 winmags with Berger 190s and some 180 accubonds ( both with H100v ), some .308s with Sierra gamechangers in 180 starting into my last couple pounds of 4064.

Fixes knee, hurts shoulder!

Just kidding, happy to see you*re out and about doing well!

[Square Bag]

Typical weekend to the range (back yard)

That’s a lot of cleaning!

[27hand]

https://www.flickr.com/gp/101828248@N08/BoQP9H

Got out to Pitcairn Monroeville club.

Started bad. Dave was cutting grass and the 300 yard was down.

I went to the 50 to test fire my 30-30 after changing the rings, lapping them and bore sighting the Marlin 336.

Chrono didn't work ( I wanted to see what my reloads flew at).

Shot to 3030 and an AR which I was going to do a 36 yard zero but forgot a target stand to set up at 36 so a 50 it was.

Dave finished. I had to pick up all my shit and move to the 300.
I set targets at 100,200 and 300.

I actually took too much stuff.
I ran the Savage at 200 and 300 and got just over a minute at 300.
I shot the Tikka with a few loads that showed promise at 100 and got one under a minute at 300. (Need to shoot more).

Shot and zeroed the 30 30 a couple inches high at 100. Chrono worked ?????.

The knee was bothering me but I shot 2 of the 3 ARs I took.
The one with the ACOG clone hit a few plates at 300.
I took steel Wolf,wolf gold, LC xm193, ppu brass and another brass cased 556.


I'll have to work.up the 165 Accubonds.


It was good being out but I think I have to focus on just a few instead if taking too much stuff.

[ViperHummel]

Went to Wexford SGL. Also a grass cutting day, but I only waited 10-15 minutes for him finish the 100 yard range, and I had it to myself afterwards.

It was a so so day. Went to test a 7.62x39 using a POF Midlength. Went fine for the most part. I was tuning and note taking. Switching between different springs and buffers. Used Tula most of the time and it failed lock back a few times, but other times, no issues. Going back out Wednesday and will take some Red Army.

It grouped ok. I was getting fatigued from the constant part swapping. Hope to take my rest out next time and take me out of the equation.
BD970ED7-183A-4ABA-9335-53E4D66D03EF.jpg

The shit part was the LW build I did back on 2013. The thing kicks like a mule and I had left it in the back of the safe since. I had hopped after diagnosing some issues I had it corrected. With a sprinco extra strength spring and h3 buffer, it still bruises. Ripped it apart (ruining the BCM .625 gas block... over zealous with red Loctite as it was my 2nd complete assembly.)

Gas port is .093+ and it*s carbine!! Ugh. Brownells *premium* barrel that
Is no longer offered. Back then, I was still learning. Might go for an adjustable or a something from BRT to mitigate gas. Might not be worth it though either. The barrel was like $260-280 back then. After almost 7 years, might just chock it up as a loss.

[Cville]

Went to a local range today to sight in a few firearms and to test fire the 1895 Winchester

[rifleshooter2]

Hit the range with a few pieces today. I love this 12 gauge most of all. https://youtu.be/U8o__HFOrM4

[Palerider]

Damn near perfect Friday afternoon taking the Pony*s out for a run!

[Walleye Hunter]

There it is, I thought there was a range thread. And now I see why I couldn't find it.