Results 1 to 3 of 3
-
July 30th, 2011, 09:41 PM #1
Senior Member
- Join Date
- Nov 2010
- Location
-
Indy,
Indiana
- Posts
- 317
- Rep Power
- 1940
Beefing up the cylinder-pivot-bar
Where might I find on line an expanded view of the Taurus Judge 3-in x 3-in "magnum" wheel-gun? Would it be a maximum difficulty project to install a stronger pin to support the cylinder? Anyone done this on ANY sort of revolver? Thanks. L1S1
"1"starts the Militia; you are not alone but fight as though you are.
-
July 31st, 2011, 08:34 AM #2
Super Member
- Join Date
- Mar 2008
- Location
-
Sciota,
Pennsylvania
(Monroe County) - Posts
- 672
- Rep Power
- 4504
Re: Beefing up the cylinder-pivot-bar
The Taurus manual has exploded views in it. Otherwise get it off their site: http://www.taurususa.com/pdf/metallic-pistol-manual.pdf
-
July 31st, 2011, 08:56 AM #3
Grand Member
- Join Date
- Mar 2011
- Location
-
mechanicsburg,
Pennsylvania
(Cumberland County) - Posts
- 1,243
- Rep Power
- 8954928
Re: Beefing up the cylinder-pivot-bar
having problems? if you are let us all know whats up, so we don,t have to deal with them as well. my thoughts go as follows if it ain,t broke don,t fix it.
Reply With Quote
Similar Threads
-
Weaver Bases- one, two and pivot
By WPNFXER in forum GeneralReplies: 1Last Post: September 5th, 2009, 06:36 PM -
Smith Wanted: pivot pin detent hole drill
By avizpls in forum GeneralReplies: 22Last Post: February 10th, 2007, 12:27 PM
Bookmarks