Results 1 to 1 of 1
Thread: Taurus 66
-
July 1st, 2011, 05:02 AM #1Junior Member
- Join Date
- Jul 2011
- Location
-
Audubon Park,
New Jersey
- Posts
- 2
- Rep Power
- 0
Taurus 66
I have a Taurus 66 and want to remove the yoke from the cylinder. I did this awhile back but forget how. I know this isn't nessessary but I see crud I can't get to.
Sorry for the post guys.... I was fooling with it this morning and got it apart. But another question about the extractor/rod.
It hangs up in the yoke a little and doesn't return sometimes... The rod hangs up somewhere in the yoke. I think it's hanging up on the spring. When I tighten the rod and back off from tightened, it doesn't hang up. Is there something I should replace?
The gun has about 1500 rounds through it.
Also... what parts should be replaced on the occassion? Like the spacer bushing, extractor, which on the extractor rod I noticed wear, due to what looks to be aluminum.Last edited by loader; July 1st, 2011 at 06:27 AM.
Similar Threads
-
Taurus TCP
By Asmodeus6 in forum PistolsReplies: 46Last Post: September 11th, 2011, 07:02 AM -
Taurus PT940 (aquired used): Works/shoots Fine, But Would You Send This To Taurus?
By marks in forum PistolsReplies: 16Last Post: May 29th, 2011, 12:12 PM -
NIB Taurus PT 24/7 PRO DS
By Walther22 in forum GeneralReplies: 1Last Post: April 15th, 2009, 08:51 PM -
New Taurus pt 111 9mm
By rspowers in forum GeneralReplies: 7Last Post: October 31st, 2007, 12:22 PM
Bookmarks