Results 11 to 15 of 15
Thread: CDI Custom Knife and Gun
-
March 20th, 2012, 08:02 PM #11
Re: CDI Custom Knife and Gun
So after i booger-jacked my 870 forend I called Sean and went right over. I f-ed up the threads and he got it back to working again. An awesome gunsmith!
DISCOUNTS - Steel Target Paint: beaverje10 (10% off) | Wiland USA: jbeaver05 (5% off)
-
June 18th, 2012, 12:18 AM #12
Re: CDI Custom Knife and Gun
In the last couple of months Sean has done sights on one of my Glocks and my LC9. He also just pinned/welded a flash suppressor on a 14.5" barrel of mine. All nicely done. A+ work and very affordable.
I'll be calling him this week for threading a bull barrel once my muzzle brake comes in"If guns cause crime then all of mine are defective." -Ted Nugent
-
September 3rd, 2012, 08:38 PM #13
Re: CDI Custom Knife and Gun
Giving kudos to Sean for another job well done. Had him remove a stripped set screw from a low profile gas block. Additionally, he installed three free float hand guards for three of my uppers. Exceeded promised turn-around time. Would definitely recommend.
-
September 17th, 2012, 06:26 PM #14Active Member
- Join Date
- May 2006
- Location
-
Pennsylvania
(Lehigh County) - Posts
- 228
- Rep Power
- 457488
Re: CDI Custom Knife and Gun
I had Sean convert my HK45C from Variant 1 to the light LEM configuration. He did a great job and I highly recommend him.
-
October 5th, 2012, 01:23 AM #15
Re: CDI Custom Knife and Gun
Another positive vote for CDI. Just picked up a 5.56 barrel that Sean cut down to 10.5 and threaded. The flash hider was perfectly indexed relative to the upper receiver. Also had him pin/weld a flash hider to a 14.5" barrel, another perfectly indexed setup.
"If guns cause crime then all of mine are defective." -Ted Nugent
Similar Threads
-
CDI Custom Knife & Gun in Chalfont
By cyclesteel in forum GunsmithsReplies: 42Last Post: August 6th, 2018, 07:00 PM -
custom knife collection
By normaj in forum GeneralReplies: 0Last Post: September 8th, 2009, 06:18 PM -
Custom Knife Sheath for SERPA
By Ten*K in forum GeneralReplies: 3Last Post: May 27th, 2009, 03:10 AM -
Derespina Model BK#1 Knife Custom made Rare
By Derespina Knives in forum GeneralReplies: 0Last Post: April 1st, 2009, 07:09 PM -
custom knife interest?
By fslflint in forum GeneralReplies: 24Last Post: July 9th, 2007, 05:45 AM
Bookmarks