Results 21 to 23 of 23
-
July 23rd, 2010, 11:09 PM #21Grand Member
- Join Date
- Dec 2007
- Location
-
Philadelphia,
Pennsylvania
(Philadelphia County) - Posts
- 1,113
- Rep Power
- 4518298
Re: SAIGA Rifle Trunnion drill and tap?
Saiga has 14 parts.
(1) Receiver
(2) Barrel
(3) Trunnion
(4) Muzzle attachments
(5) Bolt
(6) Bolt carrier
(7) Gas piston
(8) Trigger
(9) Hammer
(10) Disconnecter
(11) Buttstock
(12) Pistol grip
(13) Forearm handguards
(14) Magazine body
(15) Follower
(16) Floorplate[/QUOTE]
Any US parts that you add don't count towards your foreign parts total. Assuming your pistol grip and muzzle device are US made, you only need to remove 4 foreign parts. If you decide to add a foreign made muzzle device then the next easiest part to replace would probably be the handguard.
-
September 25th, 2010, 05:14 PM #22Super Member
- Join Date
- Apr 2010
- Location
-
Saigaland,
Pennsylvania
(Centre County) - Posts
- 890
- Rep Power
- 400433
UPDATE
I've finished the bullet guide and I must say, even being my first time and using only a hand drill, it was pretty simple. It went flawlessly and was the best part of the conversion process!(beside cycling rounds through with a 30 rounder for the first time!)
I hope to have a picture up soon....man I love that SAIGA!
Thanks for all your help guysHunting is NOT a 2nd Amendment Activity
-
September 26th, 2010, 12:02 PM #23
Re: SAIGA Rifle Trunnion drill and tap?
here is a picture of my 20" barrel saiga.
http://thegunwiki.com/Gunwiki/BuildS...rifyCompliance
and here is a link to the best saiga compliance list i have found. (even though another board member has givin it to you already)
here is what i used in my conversion.
1)tapco gas piston .......1 us part
2)tapco 20 round mag ......3 us parts
3)tapco g2 trigger.............3 us parts
4)romanian surplus wood funiture....0 us parts
5)bakelite red romanian pistol grip.....0 us part
6)bulgarian front sight block with 24 mm ak74 muzzle brake....0 us parts
total 7 us parts
If i left the ugly black us made stock and pistol grip i could use the communist steel mags, but i love the look of the romanian AKM furniture,and the tapco mags work good for me at the local range where LOE might run up on me and check compliance count!
make sure you post pics of your saiga.
Similar Threads
-
Which Saiga rifle to buy??
By phillychoppin in forum GeneralReplies: 16Last Post: January 14th, 2010, 08:53 AM -
ak rear trunnion screw
By david1 in forum GeneralReplies: 6Last Post: December 10th, 2009, 09:29 AM -
1903 Drill Rifle Barrelled Receiver-Wmpt
By dhoundsman in forum GeneralReplies: 2Last Post: August 11th, 2009, 07:30 AM -
1903A3 deactivated drill rifle $100
By VeeVee in forum GeneralReplies: 0Last Post: March 2nd, 2009, 01:23 PM -
WTT: 2 NIB Saiga Rifle conversions
By Major Auggie in forum GeneralReplies: 8Last Post: June 14th, 2008, 01:00 PM
Bookmarks