Results 1 to 7 of 7
-
March 30th, 2019, 02:12 PM #1
M&P 2.0 slide and frame interchangeability?
I have an M&P 2.0 9mm full size and a 2.0 .40 compact size. If I put the full size 9mm slide on the compact .40 frame, will it function fine?
"The Constitution is the guide which I will not abandon.” - George Washington
-
April 1st, 2019, 02:26 PM #2
Re: M&P 2.0 slide and frame interchangeability?
I have both a compact (4 inch bbl) and full size (4.25 inch bbl) M&P 2.0 and have swapped the slides and shot it. It worked, yet I only shot a limited number of rounds. I cannot guarantee how it would hold up over time, but it worked...
Join the groups protecting your rights from the fools trying to take them from you!
-
April 1st, 2019, 02:51 PM #3
Re: M&P 2.0 slide and frame interchangeability?
One thing to consider is the ejector. The Glock .40 ejector is different than the 9mm ejector to accommodate the larger diameter case. I don't know about M&Ps specifically though.
-
April 1st, 2019, 06:08 PM #4
-
April 22nd, 2022, 08:33 PM #5
Re: M&P 2.0 slide and frame interchangeability?
I have the Smith Wesson 2.0 compact 9m. I can't get the rear sight screw out. Where can I see on youtube how to heat it. Thx.
-
April 22nd, 2022, 09:01 PM #6
-
April 23rd, 2022, 05:32 PM #7
Re: M&P 2.0 slide and frame interchangeability?
Thx. for the reply. I was using a iron for lead for resistance etc on a board. But I didn't try tightening first and broke the allen. I'l look for a harder allen.wrench. By the way, What is the size allen of the wrench?
Similar Threads
-
Gen 1 Glock 17 slide on Gen 3 frame?
By BerksCountyDave in forum PistolsReplies: 2Last Post: January 5th, 2010, 07:23 PM
Bookmarks