Results 1 to 7 of 7
-
June 16th, 2009, 05:43 PM #1
Brian, This is what I was talking about
Since I can't attach pics in PM, here it be
-
June 16th, 2009, 06:00 PM #2
Re: Brian, This is what I was talking about
is there a +/- on the 9.625" and 5.25" lengths?
and what thickness or rather how stout does it have to be?
thinking maybe .1875" thick tops or maybe hair thinner with a gusset on the back?
i assume there can a radius on the joint corner?
i can bend this from a single pc, instead of trying to keep two small pcs square before and after welding.it's only metal, we can out think it....
-
June 16th, 2009, 06:13 PM #3
Re: Brian, This is what I was talking about
+/- Can be up to 1/8" with minimal to no impact on function
Radius of the joints, if joints are needed (See below), no issue
The stoutness need that I am claiming is over stated, well to scale it should be strong as the precision needed, I don't want the mounting to lend any variance.
No doubt to the 1 piece design. I just need the base wide enough to displace the pressure and provide enough distance for the mounting points. The goal is to have the cutter due to the work, but while I am spinning at high rpm I don't want anything throwing off the center which could hinder my forward progress :P
PS> You might want to make this easy to mass produce, well not "Mass" but be able to make in a very timely fashion if it works.Last edited by Fr0sty; June 16th, 2009 at 06:20 PM.
-
June 27th, 2009, 01:49 PM #4
Re: Brian, This is what I was talking about
did'nt forget, just have not got to it yet.
it's only metal, we can out think it....
-
June 28th, 2009, 01:58 AM #5
Re: Brian, This is what I was talking about
Ohh no a steel target sooo advanced, and fitted with radar absorbing paint. Bullets are gonna be dodged by it. The government will confiscate it, and its creators. Nice knowing you folks.
Brad.
-
June 28th, 2009, 02:05 AM #6
Re: Brian, This is what I was talking about
wonder if they'll take the paint too, could use it for my truck so I can drive faster.
Honesta Mors Turpi Vita Potior ~ 3%
-
July 6th, 2009, 08:34 AM #7
Re: Brian, This is what I was talking about
Brian,
Chop chop, or your fired!
Similar Threads
-
Just had to share Brian's 16" Socom throwing flames
By Fr0sty in forum GeneralReplies: 10Last Post: May 24th, 2009, 09:39 PM -
Conan O'Brian & NBC Support Guns?
By RONNIE77 in forum GeneralReplies: 16Last Post: February 25th, 2009, 06:47 PM -
Alan Gura/Brian Siebel debate on the Heller decision
By Johannes_Paulsen in forum GeneralReplies: 0Last Post: September 25th, 2008, 05:40 PM
Bookmarks