Results 1 to 3 of 3
-
December 17th, 2009, 08:18 PM #1
~ Taking a FAL rifle apart into two shorter chunks
Have a FAL rifle that might need to be shipped at some point. My question is . . . Would there be any special requirement to remove that big ugly hinge screw thing that acts as a pivot point to the top and lower section?
Looks as if it would require a big wide blade screw driver. Just concerned about possible breaking or stripping out something.
Thanks in advance.
-
December 17th, 2009, 10:30 PM #2
Re: ~ Taking a FAL rifle apart into two shorter chunks
I use a coin ( a nickel IIRC) and a pair of pliers to remove the screw. It must be turned while the action is closed tho, or it will spin endlessly.
-
December 18th, 2009, 12:03 AM #3
Re: ~ Taking a FAL rifle apart into two shorter chunks
Thanks for the info . . . The cumbersome rifle came apart easily into two Bit Size chunks.
Similar Threads
-
Shorter Mosin deer rifle
By Huggy in forum GeneralReplies: 6Last Post: October 20th, 2009, 10:32 AM -
That wasn't the soap that "Love Chunks" just dropped
By King 5.45 in forum GeneralReplies: 2Last Post: August 8th, 2009, 07:25 PM -
taking a rifle to jersey!-dolt
By rich6675 in forum GeneralReplies: 4Last Post: May 8th, 2009, 12:21 AM -
WTT: Full size Ar upper for a shorter one.
By Brown-Bear in forum GeneralReplies: 0Last Post: September 13th, 2008, 04:38 AM -
I'll be taking that rifle, Mr. Heston
By Ten*K in forum GeneralReplies: 2Last Post: April 6th, 2008, 10:51 AM
Bookmarks