Pennsylvania Firearm Owners Association

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Welcome to the Pennsylvania Firearm Owners Association Forum, we hope you like what you find here and we strongly encourage you to register for an account with us, especially if you are from Pennsylvania. Once registered you will have access to participate in our community. Thanks for visiting and we hope you become a regular!
Attention! There has been an influx of scammer signups!

The method of operation is to private message you and tell you that you should contact such 'n such person at a given email address.

Please report the private messages. Staff will ban the offender, and I will implement an IP ban. Unfortunately these scammers are using VPN/proxy services, which may mean your VPN/proxy may be blocked.
Attention! About VPN's and foreign IP addresses.

When signing up, do so from a US based Internet Service Provider. Turn off any VPN/safe-browsing feature. Failure to do so will result with your new account denied.

If you run into a IP ban afterwards as a member, again - turn off your VPN or switch servers. We do not ban legit Internet Service Providers from the USA(exception for certain individual IP addresses). Free VPN's tend to get banned too. We try not to ban legit subscription VPN services, but they rarely label their IP blocks correctly.

If you run into an IP ban, it likely wasn't you.

Results 1 to 2 of 2

Thread: AR-15 lower receivers

Thread Tools
Display
- Linear Mode
- Switch to Hybrid Mode
- Switch to Threaded Mode

June 4th, 2008, 04:38 PM #1
RONNIE77

View Profile

View Forum Posts

Private Message

Grand Member
Join Date

May 2008

Location

Philadelphia, Pennsylvania
(Philadelphia County)

Age

46

Posts

1,047

Rep Power

175
AR-15 lower receivers

Doing my first AR build, and was curious to know about the quality of Patriot Ordinance Factory (POF) lower receivers. Any good?

Reply With Quote
June 4th, 2008, 04:44 PM #2
Xringshooter

View Profile

View Forum Posts

Private Message

Grand Member
Join Date

Jan 2007

Location

State College, Pennsylvania
(Centre County)

Age

71

Posts

5,618

Rep Power

21474859
Re: AR-15 lower receivers

I have not heard anything bad about them. Another place to check in to see what others have to say would be M4Carbine.net or AR15.com.

Ron USAF Ret E-8 FFL01/SOT3 NRA Benefactor Member

Reply With Quote

Quick Navigation General Top

Site Areas
Settings
Private Messages
Subscriptions
Who's Online
Search Forums
Forums Home
Forums
Forum
Discussion
Law & Politics
1. Pennsylvania
2. National
Marketplace
Events
Private Forums
1. PAFOA Club
Regions
1. Lake Erie Region
  1. Crawford
  2. Erie
  3. Mercer
  4. Venango
2. Allegheny National Forest Region
  1. Cameron
  2. Clarion
  3. Clearfield
  4. Elk
  5. Forest
  6. Jefferson
  7. McKean
  8. Potter
  9. Tioga
  10. Warren
3. Valleys of the Susquehanna Region
  1. Centre
  2. Clinton
  3. Columbia
  4. Juniata
  5. Lycoming
  6. Mifflin
  7. Montour
  8. Northumberland
  9. Snyder
  10. Union
4. Pocono Mountain Region
  1. Bradford
  2. Carbon
  3. Lackawanna
  4. Luzerne
  5. Monroe
  6. Pike
  7. Schuylkill
  8. Sullivan
  9. Susquehanna
  10. Wayne
  11. Wyoming
5. Lehigh Valley & Philadelphia Region
  1. Bucks
  2. Chester
  3. Delaware
  4. Lehigh
  5. Montgomery
  6. Northampton
  7. Philadelphia
6. PA Dutch Country/Hershey Region
  1. Adams
  2. Berks
  3. Cumberland
  4. Dauphin
  5. Franklin
  6. Lancaster
  7. Lebanon
  8. Perry
  9. York
7. Laurel Highlands Region
  1. Bedford
  2. Blair
  3. Cambria
  4. Fayette
  5. Fulton
  6. Greene
  7. Huntingdon
  8. Indiana
  9. Somerset
  10. Westmoreland
8. Pittsburgh Region
  1. Allegheny
  2. Armstrong
  3. Beaver
  4. Butler
  5. Lawrence
  6. Washington
Miscellaneous
1. The Lounge

« Previous Thread | Next Thread »

Similar Threads

AK Receivers

By Slotimus in forum General

Replies: 3
Last Post: May 8th, 2008, 03:57 PM
dpms lower receivers

By kar298 in forum General

Replies: 1
Last Post: March 18th, 2008, 10:58 PM
Status Update on PAFOA Lower Receivers

By Jon-Anvil_Arms in forum General

Replies: 19
Last Post: February 14th, 2008, 04:51 PM
PAFOA Custom Laser Engraved AR15 Lower Receivers

By Jon-Anvil_Arms in forum General

Replies: 1
Last Post: December 11th, 2007, 06:13 PM
PAFOA Custom Laser Engraved AR15 Lower Receivers

By Jon-Anvil_Arms in forum General

Replies: 0
Last Post: December 11th, 2007, 05:07 PM