Need a Holster

[Grizz2720]

I bought the WIF a Lady Smith and Wesson in 357. Then went and bought a Blackhawk Serpa for a J frame, I thought the Lady was a J Frame but it does not fit. So what holster do I need keep in mind the Wif does not like belts.
It will be her carry gun. Wisconsin is open carry Only for now.

[fingers80002]

I am not sure, but maybe try a SP101 holster....

[Pizza Bob]

It is a J-frame and the only issue with it not properly fitting a J-frame holster would be the barrel length and configuration. Instead of guessing, please post the model number of the gun - found under the crane on the frame of the gun. It will (should) be a 2 or 3-digit number followed by a hyphen and then another 1 or 2-digit number; i.e. 638-3

There was an engineering change that lengthened the cylinder so the J-frame could be used for guns chambered in .357 Mag, but modern holsters will accommodate both cylinder lengths.

Adios,

Pizza Bob

[inspector710]

What model # is it? I bought my wife a Lady Smith-Model 60. It is a J frame. If the LS is a Model 65, it is a K frame.

[Grizz2720]

inspector710 your right it is a J frame . Now I have to figure out why it does not fit the holester.

Thanks Guys.

[renegadephoenix]

check the passive retention screw, it might be too tight and not allowing the revolver to slide down past the active retention catch.