Pennsylvania Firearm Owners Association

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Welcome to the Pennsylvania Firearm Owners Association Forum, we hope you like what you find here and we strongly encourage you to register for an account with us, especially if you are from Pennsylvania. Once registered you will have access to participate in our community. Thanks for visiting and we hope you become a regular!
Attention! There has been an influx of scammer signups!

The method of operation is to private message you and tell you that you should contact such 'n such person at a given email address.

Please report the private messages. Staff will ban the offender, and I will implement an IP ban. Unfortunately these scammers are using VPN/proxy services, which may mean your VPN/proxy may be blocked.
Attention! About VPN's and foreign IP addresses.

When signing up, do so from a US based Internet Service Provider. Turn off any VPN/safe-browsing feature. Failure to do so will result with your new account denied.

If you run into a IP ban afterwards as a member, again - turn off your VPN or switch servers. We do not ban legit Internet Service Providers from the USA(exception for certain individual IP addresses). Free VPN's tend to get banned too. We try not to ban legit subscription VPN services, but they rarely label their IP blocks correctly.

If you run into an IP ban, it likely wasn't you.

smit308
Active Member

Mini Statistics

Join Date: April 18th, 2008

Last Activity: July 26th, 2024 04:19 PM

Tab Content: smit308's Activity; About Me

Tab Content: All; smit308; Friends; Photos

Older Activity
July 21st, 2024, 05:09 PM

smit308 replied to a thread Ar10 overgassed? in Gunsmithing

You mentioned that you were using the lightest spring. A heaver buffer spring may be in your future. Smit

see more

5 replies | 155 view(s)
July 21st, 2024, 05:09 PM

smit308 replied to a thread Ar10 overgassed? in Gunsmithing

You mentioned that you were using the lightest spring. Aheaver buffer spring may be in your future. Smit

see more

5 replies | 155 view(s)
June 29th, 2024, 05:09 PM

smit308 started a thread MAC 1014 in Shotguns

Anybody have any experience with the MAC 1014 clone? I purchased the 1014 marine, which is supposed to have a nickel finish. I'm not sure if it's...

see more

2 replies | 140 view(s)

No More Results

About smit308

Basic Information

Location Information

City:: Bethlehem

State:: Pennsylvania

County:: Northampton

Statistics

Total Posts

Total Posts: 230

Posts Per Day: 0.04

General Information

Last Activity: July 26th, 2024 04:19 PM

Join Date: April 18th, 2008

Referrals: 0

All times are GMT -4. The time now is 11:50 PM.

smit308 Active Member

Mini Statistics

Basic Information

Location Information

Statistics

Total Posts

General Information

smit308
Active Member