Pennsylvania Firearm Owners Association

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Welcome to the Pennsylvania Firearm Owners Association Forum, we hope you like what you find here and we strongly encourage you to register for an account with us, especially if you are from Pennsylvania. Once registered you will have access to participate in our community. Thanks for visiting and we hope you become a regular!
Attention! There has been an influx of scammer signups!

The method of operation is to private message you and tell you that you should contact such 'n such person at a given email address.

Please report the private messages. Staff will ban the offender, and I will implement an IP ban. Unfortunately these scammers are using VPN/proxy services, which may mean your VPN/proxy may be blocked.
Attention! About VPN's and foreign IP addresses.

When signing up, do so from a US based Internet Service Provider. Turn off any VPN, Safe-Browsing, and/or Private Relay feature. Failure to do so will result with your new account denied.

If you run into a IP ban afterwards as a member, again - turn off your VPN or switch servers. We do not ban legit Internet Service Providers from the USA(exception for certain individual IP addresses). Free VPN's tend to get banned too. We try not to ban legit subscription VPN services, but they rarely label their IP blocks correctly.

If you run into an IP ban, it likely wasn't you.

Emptymag
Moderator Emeritus

Mini Statistics

Join Date: January 14th, 2007

Last Activity: December 7th, 2024 04:46 PM

Avatar

More 66 Friends

Tab Content: Emptymag's Activity; About Me; Friends

Tab Content: All; Emptymag; Friends; Photos

Older Activity
December 7th, 2024, 04:42 PM

Emptymag replied to a thread 🇺🇸 DECEMBER 7 1941 in General

The hairs on my arms stood up when I saw the thread title. God bless them all.

see more

5 replies | 95 view(s)
December 7th, 2024, 12:00 PM

Emptymag replied to a thread 🤗 Florida Tampa Deputy Shoots Man Holding Woman At Knifepoint in General

Holy poop!

see more

7 replies | 190 view(s)
December 6th, 2024, 12:16 PM

Emptymag replied to a thread Share Deals on Guns Ammo Accessories Here in General

NOTE: THAT specific model number is for COMMERCIAL SPEC buffer tubes - that STOCK will not fit MIL-SPEC buffer tube. Also, 10 round mag...

see more

26328 replies | 14805646 view(s)
December 5th, 2024, 08:35 PM

edstephan replied to a thread [Want To Sell] A few firearms For Sale in Firearms

bump

see more

3 replies | 2987 view(s)
December 5th, 2024, 08:32 PM

edstephan replied to a thread [Want To Sell] 5lb can of industrial pistol powder $150.00 in Ammunition & Reloading

bump

see more

9 replies | 3180 view(s)
December 4th, 2024, 12:50 AM

Emptymag replied to a thread PA Counties locked down in General

Oh my. This is such a surprise. Who would have thought that the government was manipulating the truth?

see more

1152 replies | 167717 view(s)
December 3rd, 2024, 12:21 AM

Emptymag replied to a thread What did you buy yourself today - PART 2 in Gun Pictures

Cool. No luck for my somewhat obscure F.I. Industries Model D (Star Model D, "clone" of OLD Colt Pony)

see more

1343 replies | 226624 view(s)
December 2nd, 2024, 11:21 PM

Emptymag replied to a thread What did you buy yourself today - PART 2 in Gun Pictures

Wow. It's too bad you can't put grip panels on a Glock! If they can make a Beretta look good, it could do the same for a Glock! Those are sweet!...

see more

1343 replies | 226624 view(s)
December 1st, 2024, 07:16 PM

Emptymag replied to a thread Winchester Model 06 pump 22 S-L-LR value? in Rifles

I dunno. Ten years ago when I was looking for a pump 22, everything old and "Winchester", or "Marlin" was $400 +

see more

6 replies | 186 view(s)
December 1st, 2024, 11:23 AM

Emptymag replied to a thread Winchester Model 06 pump 22 S-L-LR value? in Rifles

see more

6 replies | 186 view(s)
December 1st, 2024, 11:08 AM

JDA58 replied to a thread Winchester Model 06 pump 22 S-L-LR value? in Rifles

following.. Mine is a 1910 manufacture date.. but I've replaced the wood and the Magazine Tube, with an after market set from Numrich not looking...

see more

6 replies | 186 view(s)
November 29th, 2024, 02:56 PM

Junior replied to a thread [Want To Sell] M1 Carbine mags in Firearm Parts & Accessories

Bump

see more

2 replies | 410 view(s)
November 28th, 2024, 10:42 PM

Emptymag replied to a thread Share Deals on Guns Ammo Accessories Here in General

Must have been a year or two before that when I got a Hi-Point 9mm carbine from Dunham's - Black Friday $119.99

see more

26328 replies | 14805646 view(s)
November 28th, 2024, 09:13 PM

Emptymag replied to a thread Share Deals on Guns Ammo Accessories Here in General

I found the sale flyer for Dunham's Black Friday sale - 2006 (I used to keep these flyers, but threw a bunch out. Kept a few. Took these pics)

see more

26328 replies | 14805646 view(s)
November 28th, 2024, 01:02 AM

Emptymag replied to a thread Share Deals on Guns Ammo Accessories Here in General

Holy fuck. NOW Chicago Knife Works says Orders over ONE pound will incur shipping charges! It was TWO pounds before. I've placed two orders...

see more

26328 replies | 14805646 view(s)
November 27th, 2024, 11:57 PM

Emptymag replied to a thread Share Deals on Guns Ammo Accessories Here in General

Don't recall if you post in/watch the knife thread, but here's a simple fix if you find that the Mora sheath is not secure to your liking. I find...

see more

26328 replies | 14805646 view(s)