Pennsylvania Firearm Owners Association

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Welcome to the Pennsylvania Firearm Owners Association Forum, we hope you like what you find here and we strongly encourage you to register for an account with us, especially if you are from Pennsylvania. Once registered you will have access to participate in our community. Thanks for visiting and we hope you become a regular!
Attention! There has been an influx of scammer signups!

The method of operation is to private message you and tell you that you should contact such 'n such person at a given email address.

Please report the private messages. Staff will ban the offender, and I will implement an IP ban. Unfortunately these scammers are using VPN/proxy services, which may mean your VPN/proxy may be blocked.
Attention! About VPN's and foreign IP addresses.

When signing up, do so from a US based Internet Service Provider. Turn off any VPN/safe-browsing feature. Failure to do so will result with your new account denied.

If you run into a IP ban afterwards as a member, again - turn off your VPN or switch servers. We do not ban legit Internet Service Providers from the USA(exception for certain individual IP addresses). Free VPN's tend to get banned too. We try not to ban legit subscription VPN services, but they rarely label their IP blocks correctly.

If you run into an IP ban, it likely wasn't you.

Gary Wiesner
Junior Member

Mini Statistics

Join Date: April 29th, 2024

Last Activity: May 24th, 2024 09:32 AM

Tab Content: Gary Wiesner's Activity; About Me

Tab Content: All; Gary Wiesner; Friends; Photos

Older Activity
May 24th, 2024, 09:31 AM

Gary Wiesner replied to a thread [Want To Sell] Glock 40 Gen 4 10mm Factory MOS cut(USED) in Firearms

Bump

see more

3 replies | 689 view(s)
May 14th, 2024, 05:25 PM

Gary Wiesner replied to a thread [Want To Sell] Glock 40 Gen 4 10mm Factory MOS cut(USED) in Firearms

Bump

see more

3 replies | 689 view(s)
May 6th, 2024, 03:04 PM

Gary Wiesner replied to a thread [Want To Sell] Glock 40 Gen 4 10mm Factory MOS cut(USED) in Firearms

Bump

see more

3 replies | 689 view(s)

No More Results

About Gary Wiesner

Basic Information

Location Information

City:: Williamsport

State:: Pennsylvania

County:: Lycoming

Statistics

Total Posts

Total Posts: 0

Posts Per Day: 0

General Information

Last Activity: May 24th, 2024 09:32 AM

Join Date: April 29th, 2024

Referrals: 0

All times are GMT -4. The time now is 02:20 PM.

Gary Wiesner Junior Member

Mini Statistics

Basic Information

Location Information

Statistics

Total Posts

General Information

Gary Wiesner
Junior Member