GUNSMITH NEEDED

**OLIN357** · May 14th, 2009, 06:45 AM

NEED A GUNSMITH TO INSTALL A V SPRING ON A CHARLES DALEY 410.....OLDER MIRUKO..AND KNOWS WHAT THEY ARE DOING

**CommonHighrise** · May 14th, 2009, 09:36 AM

I'd recommend Handgunner in Topton, unless there's a forum member closer to you I don't know about.

**Durandal** · July 13th, 2009, 09:49 AM

I recommend Michael Hane in Zieglerville, just down the road from you. He's worked on a few of my guns. Very good work, reasonable prices.

Check him out here: http://www.mhgunsmithing.com/

**zzeiber** · July 13th, 2009, 10:02 AM

It's a drive but Heavenllings Guns and Gunsmithing in Palmyra is a goods bet. He's the chief gunsmith for KBI who are the importers for Charles Daly.

There's also Rob Horse of Firearm Solutions in Birdsboro whom I hightly recommend. I get all my work done there.

**Blackthorn370** · July 17th, 2009, 05:10 PM

I would call Dick Repko at Firearms Service Center in Pottstown (610) 323-1916
The guy has been doing gunsmithing for longer than most of us have been alive and the guy who he is training to eventually take over his business is no slouch either.

Originally Posted by OLIN357

NEED A GUNSMITH TO INSTALL A V SPRING ON A CHARLES DALEY 410.....OLDER MIRUKO..AND KNOWS WHAT THEY ARE DOING

**dedrisc0** · December 11th, 2009, 12:41 PM

You can actually buy a tool set up that truly makes the job much much easier. If interested I will send you the source info and if you arein a bind I could lend you mine via ups.

Semper Fi
Dave