Results 1 to 4 of 4
-
May 4th, 2016, 07:11 PM #1
Need hellp finding Rings for my scope
I have been trying to find the correct rings for the Vortex Diamond Back 3x9x40 scope for my Mark X Interarms 30-06. I called High Standard who purchased Interarms but they do not have much information. They gave me a few numbers but nothing that helped. I cant seem to find much information on the Mark X Mannlicher 30-06 itself which makes it even more difficult. If any one has any input or can point me in the right direction it would be much appreciated.
-
May 4th, 2016, 07:54 PM #2Senior Member
- Join Date
- Feb 2012
- Location
-
berks,
Pennsylvania
(Berks County) - Posts
- 389
- Rep Power
- 152208
Re: Need hellp finding Rings for my scope
Are you looking for rings only or also need to find the correct base?
If you need the ring base Leopold 49988 is the 1 piece base in gloss finish.
The base used is for an FN Mauser.
If you are looking for rings to go with the above base, Leopold 49900 are 1" rings that will work for up to a 42mm objective.
I should also add that in the event the top of the receiver is cut like the Howa 1500 you will need the Leopold 2 piece base 51700 The 51700 set has a taller rear base than the standard 2 piece FN Mauser set. A straight edge across the top of the receiver will let you know if you need the thicker rear base.
I have never experienced this on a Mark X, but know there were several manufacturers building rifles on the tooling that built the Mark X over the years.
Hope this helps!Last edited by tripleS; May 4th, 2016 at 08:10 PM.
-
May 4th, 2016, 07:57 PM #3
Re: Need hellp finding Rings for my scope
I need the base as well. Thanks I will check into them.
-
May 6th, 2016, 02:56 PM #4
Re: Need hellp finding Rings for my scope
Both drilled and undrilled.
http://www.egwguns.com/index.php?p=c...erarms&x=0&y=0
You can buy rings from the same place, too, if you choose.
and in case you need to bed your base;
Last edited by animalmother85; May 6th, 2016 at 03:00 PM.
Similar Threads
-
Need help finding scope rings for my Interarms Mark X Mannlicher 30-06
By harty in forum GunsmithingReplies: 2Last Post: May 17th, 2016, 09:05 PM
Bookmarks