Results 1 to 4 of 4
Thread: Disassembly, FEG model GKK-45
-
March 15th, 2010, 05:36 PM #1Junior Member
- Join Date
- Dec 2009
- Location
-
Crestone, Colorado,
Colorado
- Posts
- 6
- Rep Power
- 0
Disassembly, FEG model GKK-45
Does anyone have disassembly instructions for a (very nice) .45ACP FEG model GKK-45? Thanks in advance. NOLA
-
March 16th, 2010, 11:01 AM #2
Re: Disassembly, FEG model GKK-45
NOLA:
The FEG GKK-45 is a large double-action single-stack handgun that is very similar internally to S&W and Ruger semi-autos. It has a slide-mounted safety.
The general disassembly goes as follows:
1) Remove the magazine and rack the slide ensuring the chamber is empty.
2) Put the safe "ON". (Tilted down)
3) Retract the slide and engage the slide stop in the notch.
4) From the right side of the hangun, push the slide stop pin to start it coming out of the left side. You may have to hold the slide back to take some of the force of the slide off of the slide stop.
5) Once the slide stop is started out, pull it out the rest of the way with your fingers.
6) Slide the slide/barrel assembly forward off the frame.
7) CAUTION: With the slide assembly upside-down on the bench or table and using care to control the recoil spring and guide assembly, partially compress the recoil spring by pushing forward a bit on the guide flange and remove the spring/guide assembly from in front of the recoil lug. Set aside.
8) To remove the barrel, tilt the chamber end upward and remove toward the rear of the slide.
Disassembly is in reverse.
HTH,
Noah
-
March 17th, 2010, 12:37 PM #3Junior Member
- Join Date
- Dec 2009
- Location
-
Crestone, Colorado,
Colorado
- Posts
- 6
- Rep Power
- 0
Re: Disassembly, FEG model GKK-45
Noah, Thanks for the assistance and your knowledge. All disassembled per your instructions...as a gunsmith with over a dozen years on the bench, this one was a real puzzle to disassemble. Thanks again. NOLA
-
March 17th, 2010, 06:25 PM #4
Similar Threads
-
Rem 870 Bolt disassembly
By Dextrimental in forum ShotgunsReplies: 4Last Post: March 17th, 2010, 09:13 PM -
Remington 141 Gamemaster disassembly...
By jhomich in forum GeneralReplies: 11Last Post: October 17th, 2009, 01:50 AM -
Glock magazine disassembly
By glockmaster in forum GeneralReplies: 14Last Post: September 7th, 2009, 09:10 AM -
AR-15 magazine disassembly
By Chilly Willy in forum GeneralReplies: 11Last Post: December 21st, 2008, 04:31 PM -
1911 disassembly
By axmdr40 in forum GeneralReplies: 6Last Post: May 17th, 2007, 10:24 PM
Bookmarks