Results 1 to 2 of 2
Thread: Polymer frame questions
-
March 12th, 2010, 08:18 PM #1
Polymer frame questions
So, as I have mentioned in another thread, I picked up a used HK usp compact. Another issue that it had, other than the mag, was that there was a gash on the grip area of the polymer frame. It is about 1.5 mm deep and 3-4 mm wide. Its on the grip where the right side and front side meet.
1) Can that be refinished/fixed at all?
2) Can that affect performance? I've read about and seen some vids of HK polymer frames cracking.
Thanks!
c1Last edited by SierraPapa; March 12th, 2010 at 08:20 PM.
The only maxim of a free government ought to be to trust no man living
with power to endanger the public liberty. -John Adams
-
March 12th, 2010, 08:50 PM #2Active Member
- Join Date
- Nov 2009
- Location
-
Dover,
Pennsylvania
(York County) - Posts
- 105
- Rep Power
- 20
Re: Polymer frame questions
I don't know about refinishing. I really doubt a gash will cause a crack on today's polymer frames. If you are that concerned, I'd call HK. Personally, I would lose no sleep over it.
Similar Threads
-
Ruger MKIII and MKII 22/45 Polymer Grip Frame Aftermarket Grips
By TechTeach in forum GeneralReplies: 0Last Post: September 7th, 2009, 01:09 PM -
Rugers new Polymer Frame Snubbie
By Mtbkski in forum GeneralReplies: 32Last Post: March 5th, 2009, 04:27 PM -
PMC 223 polymer csings
By glockguy68 in forum GeneralReplies: 2Last Post: August 4th, 2008, 05:02 PM -
Wilson Combat KZ polymer frame 1911
By Shawn.L in forum GeneralReplies: 13Last Post: July 13th, 2008, 03:48 PM
Bookmarks