FINALLY got it all together

[unclemoak]

This project has been going on something like 15 months. I was finally able to get it assembled and out to the range on Friday and Saturday.

[CHEMICAL]

sweet!...how was the range trip?

[YBNORMAL]

Looks great, love that M4s

[normanvin]

Pretty sharp..

[unclemoak]

sweet!...how was the range trip?

It was pretty good, though quite cold out.

The one thing that I did screw up when I went on Friday was forgetting to tighten the bolts that hold the M4s to the Larue mount, so it loosen up a good bit on me and was all over the place. I didn't take all my tools so I just had to deal with plinking and not being too accurate. I was sure to tighten them up and was good to go when I went back out on Saturday.

[YosemiteSam]

Who made the curved trigger guard.

[unclemoak]

Who made the curved trigger guard.

Magpul. They make one out of aluminum like I have and they also make an plastic injection molded one as well.

[YosemiteSam]

Magpul. They make one out of aluminum like I have and they also make an plastic injection molded one as well.

Thank you! It will make it a lot safer to shoot with winter gloves.

[aubie515]

What are the specs of your build. Looks good...I like that UBR stock...hopefully you bought it from AIM since they had a coupon code for the UBR for roughly $200.

The Magpul enhanced trigger guards are nice...I've owned the aluminum ones and to be honest I like the polymer ones better...they seem to fit easier and it's less expensive.

[unclemoak]

What are the specs of your build. Looks good...I like that UBR stock...hopefully you bought it from AIM since they had a coupon code for the UBR for roughly $200.

The Magpul enhanced trigger guards are nice...I've owned the aluminum ones and to be honest I like the polymer ones better...they seem to fit easier and it's less expensive.

I actually bought the UBR about a year ago for around $265 if I remember correctly.

Specs:

upper receiver - Larue
Lower Receiver - Spike's (should have gone with a nicer one)
LPK - Rock River Arms <-- I'll probably eventually swap in a nicer non-mil spec trigger.
Stock - Magpul UBR
BCG - Denny's Guns M-16 Super Duty
Barrel - Noveske 12.5" stainless Crusader in 5.56
Rail - Knight's Armament mid-length URX II
brake - Knight's Armament Triple Tap
Optic - Aimpoint M4s w/ Larue mount

I'm still am looking for a rear BUIS that fits my fancy and I'll probably throw some sort of hand stop or foregrip on it, then maybe a light.