Results 1 to 2 of 2
-
January 12th, 2010, 12:15 AM #1
Making corrections on Form 1 prior to mailing it out?
I just got back my Form1 from my PD to register for a 10.5" lower. However, I had a sudden change of heart and wanted to go with a 11.5". Can I white out the 10.5" and write in the desired 11.5" along with changes to the overall length? I believe a 11.5" bbl will give an overall 26" since I had 25" for the 10.5"?
EDIT: I have been advised not to make changes to the form.
Is it necessary to have a new form filled out and signed over again? Or is it okay to run a 11.5 on a registered 10.5" lower?Last edited by FJR86; January 12th, 2010 at 12:37 AM.
-
January 12th, 2010, 06:56 AM #2
Re: Making corrections on Form 1 prior to mailing it out?
It is OK to make corrections on the form.
Just take a pen, put a line through the incorrect info, then initial it.
then put the correct info above(or below) it.
You are submitting a form to manufacture a firearm. The Govt. wants to know the configuration at the time of manufacture.
General consensus is that as long as you have the means to return it to the "as manufactured" specs. you can run any upper on it.
However if you cannot make it match the form 1, then you need to notify the ATF of the new specs.
With that in mind, don't make it to a configuration that doesn't match the form.NEVER TRUST A PRIVATE WITH A LOADED WEAPON OR AN OFFICER WITH A MAP
Similar Threads
-
Carry laws for corrections officers?
By NormanBates in forum GeneralReplies: 20Last Post: January 10th, 2018, 11:57 AM -
POSPONED DUE TO PRIOR COMITMENTS
By 338winmag in forum GeneralReplies: 7Last Post: September 10th, 2009, 01:48 PM -
Mailing LTCF form?
By scuba264 in forum GeneralReplies: 9Last Post: July 29th, 2009, 01:29 AM -
Any corrections officers on here?
By Jay5oh in forum GeneralReplies: 5Last Post: October 16th, 2008, 04:43 PM -
Woman Disarms South Carolina Corrections Officer at Hospital; Shoots Self
By larrymeyer in forum GeneralReplies: 1Last Post: August 28th, 2008, 04:28 PM
Bookmarks