Results 1 to 3 of 3
Thread: ???? for Lock N Load Owners
-
August 1st, 2007, 07:51 PM #1
???? for Lock N Load Owners
Greetings,
Does anyone own a Lock and Load Press with a case feeder?
I am in need of the height from the bench top to the top of the case feeder at its highest point. Low ceiling in basement over workbench......
With dies I already own RCBS, and have seen conflicting reports on Hornady's dies. Of course Hornady would want me to purchase their dies.Jack
-
August 3rd, 2007, 05:57 PM #2Member
- Join Date
- Feb 2007
- Location
-
Hatboro,
Pennsylvania
(Montgomery County) - Age
- 70
- Posts
- 43
- Rep Power
- 0
Re: ???? for Lock N Load Owners
It's 38 1/2 inches from the top of the bench to the top front of the case feeder.
-
August 3rd, 2007, 10:27 PM #3
Re: ???? for Lock N Load Owners
Ouch! Looks like I'm building an additional reloading bench, and in a different area.
My basement ceiling is only 5'9".
I'd be sitting on the floor, or filling the case feeder from the dining room upstairs.
Thank You!!Last edited by 1927A1; August 4th, 2007 at 06:37 AM.
Jack
Similar Threads
-
Lock N Load Presses
By 1927A1 in forum GeneralReplies: 6Last Post: July 12th, 2007, 11:23 PM -
Basic Load
By Carnes in forum GeneralReplies: 10Last Post: July 5th, 2007, 06:53 PM -
need a good 223 load
By FordDieselSteve in forum GeneralReplies: 11Last Post: April 25th, 2007, 10:58 PM -
hunting load
By pghplr in forum HuntingReplies: 1Last Post: October 15th, 2006, 03:18 PM -
Hornady Lock N Load AP
By aubie515 in forum GeneralReplies: 5Last Post: September 25th, 2006, 04:45 PM
Bookmarks