Question about Raven Concealment Systems holsters...

[colagrrl]

So I just received my new Raven Concealment Systems ACR holster in the mail and I have to say, it's definitely the cat's meow as far as appendix carry rigs go. I've tried my fair share of appendix carry holsters over the past few months and I'm happy to have finally found one that isn't going to be returned

It's a super comfortable holster and I like the fact that there's a very audible *snap* heard when the gun locks into place, but I do have a question. Is there any way to loosen up the retention on it or do I just have to practice my drawstroke a couple hundred times to get it to loosen up? Granted, the belt clips are 1 1/2" and my current gun belt is 1 1/4", but it's literally taking 2 hands to remove the gun from the holster when it's not on my belt.

And before anyone asks, I'm not attempting any of the holstering/unholstering with a loaded gun.

Any ideas or suggestions?

And here it is, in all it's Kydex beauty:

[solrac7]

Is there a tension screw on it anywhere? My Bladetech kydex hoster had a rubber bushing with a screw that adjusted the tension...

My kydex sheath for my knife was too tight - no adjustment possible - I stuffed a piece of hard plastic in between the two layers of kydex- worked like a charm. BUT I would contact the manufacturer first...

Cb