Pennsylvania Firearm Owners Association

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Welcome to the Pennsylvania Firearm Owners Association Forum, we hope you like what you find here and we strongly encourage you to register for an account with us, especially if you are from Pennsylvania. Once registered you will have access to participate in our community. Thanks for visiting and we hope you become a regular!
Attention! There has been an influx of scammer signups!

The method of operation is to private message you and tell you that you should contact such 'n such person at a given email address.

Please report the private messages. Staff will ban the offender, and I will implement an IP ban. Unfortunately these scammers are using VPN/proxy services, which may mean your VPN/proxy may be blocked.
Attention! About VPN's and foreign IP addresses.

When signing up, do so from a US based Internet Service Provider. Turn off any VPN/safe-browsing feature. Failure to do so will result with your new account denied.

If you run into a IP ban afterwards as a member, again - turn off your VPN or switch servers. We do not ban legit Internet Service Providers from the USA(exception for certain individual IP addresses). Free VPN's tend to get banned too. We try not to ban legit subscription VPN services, but they rarely label their IP blocks correctly.

If you run into an IP ban, it likely wasn't you.

Results 1 to 1 of 1

Thread: .380 FMJ for 9x19mm FMJ

Thread Tools
Display
- Linear Mode
- Switch to Hybrid Mode
- Switch to Threaded Mode

May 27th, 2009, 06:15 PM #1
JoeyBones

View Profile

View Forum Posts

Private Message

Super Member
Join Date

Jul 2008

Location

Dar al-Harb, Pennsylvania
(Montgomery County)

Age

43

Posts

902

Rep Power

3772
.380 FMJ for 9x19mm FMJ

*Trade Pending as of Friday, 5/29/09 @ 1:00 PM*

*Ammo has been traded. Thank you everyone for your interest!*

I have a 50 rd. box of Winchester WinClean .380 (95 grain, I believe)... I'm looking for 100 rds of quality factory-loaded (no reloads, please) FMJ 9mm ammo (I don't care if it's 115, 124, 147, std pressure, NATO-spec, +P+ - whatever).

Given the current state of affairs in the (un)availability of .380 ammo, I think a 2:1 ratio of your 9mm for my .380 is about fair...

I will also entertain offers with a reduced number of premium JHP 9mm carry ammo...

PM me with any interest...

Regards,

Bones

Last edited by JoeyBones; May 30th, 2009 at 07:34 PM. Reason: Ammo has been traded

Reply With Quote