Opinions on High Noon Holsters?

**unclesam099** · March 21st, 2007, 08:16 PM

Does anybody have any good/bad/other stories about these holsters?

Basically, I need an IWB for my 4" Service XD45. I wanna go for this one: http://www.highnoonholsters.com/Prod..._decision.html

Any other ideas/suggestions? Thanks all!

**dmg1969** · March 22nd, 2007, 07:37 AM

I just purchased their Skin Tite pancake holster a few weeks ago. It's an alright holster but, at least for me, my FNP-9M prints badly if I wearing anything but heavy clothing. It doesn't seem to be the whole holster that prints...just the thumb break area. I'm still on the hunt for the perfect holster for it. I'd probably do better with an IWB, but I really prefer the OWB holster...either a pancake or paddle. All in all, their product seems to be well made.

Dave G.

**41 Redhawk** · March 22nd, 2007, 10:54 AM

I have/had three of them and find them well made. I had the thumb break OWB pancake (Sky High) and did not like the thumbreak part of it. I switched to their Slide guard model http://www.highnoonholsters.com/Prod...ide_guard.htmland like it much better. I also have the Down Under IWB http://www.highnoonholsters.com/Prod...er_straps.html it too is equally well made. I will buy more a need arises.

**unclesam099** · March 28th, 2007, 11:53 PM

It came in today. It appears to be well made. My only complaint is that the stitching is a little "sharp" and can be itchy. I may modify it with a small layer or something on the side of it for comfort, but I'd have to figure that out later.

Here's the pics. I'm 6'3" and 195. It's a size small tee shirt I'm wearing and I have an XD45 4" service model. The first pic is wierd because there's a crease down the shirt from my shoulder. I have another (too big for attaching) and it doesn't print at all.

Excuse my messy room