Results 1 to 3 of 3
Thread: Another Heritage Arms question
-
December 25th, 2023, 01:15 AM #1Junior Member
- Join Date
- Dec 2023
- Location
-
Brighton,
Colorado
(Adams County) - Posts
- 1
- Rep Power
- 0
Another Heritage Arms question
I've seen other posts about the Heritage Arms Heritage Rough Rider .22; my issue seems to be a bit different and I hop in the intervening time someone may have found a solution. I have a Heritage Arms Heritage Rough Rider .22 with two cylinders a .22LR and a .22WMR. The handgun works great with the .22LR cylinder. When I install the .22WMR cylinder I have serious problems. I can get the cylinder installed, but I can only pull the hammer back to the half cocked position. I cannot bring the hammer back to a fully cocked position. When I bring the hammer back to the half-cocked position it does not rotate the cylinder to the next chamber position. Anyone have any thoughts on a solution?
Thanks, Terry
-
December 25th, 2023, 09:56 AM #2
Re: Another Heritage Arms question
Sounds like the cylinder could be slightly out of spec. Could ask if they'd take a look at it, possibly get a new cylinder. Not familiar with their warranty program but most manufacturers are decent to work with. Even Taurus.
-
December 25th, 2023, 02:42 PM #3
Re: Another Heritage Arms question
Give them a call, get a prepaid label to send the cylinder in, hopefully get shipped a replacement. That would be ideal.
Similar Threads
-
HERITAGE ARMS 17 HMR ?
By MARINE DIVISION TWO in forum PistolsReplies: 0Last Post: January 8th, 2020, 04:37 PM -
Heritage Arms CS is excellent
By Bang in forum PistolsReplies: 0Last Post: August 15th, 2016, 11:32 AM -
Bought my Heritage arms 22
By 4thdimension in forum GeneralReplies: 8Last Post: July 18th, 2016, 12:02 AM
Bookmarks