Results 1 to 4 of 4
Thread: Barrel Polishing Question
-
July 1st, 2006, 10:53 AM #1
Barrel Polishing Question
A guy at work wants to polish the part of his barrel by the ejection port and the barrel tip (about a 1/2 in.) to give it a stainless steel barrel look. He wants to do this on his Glock 17. I advised him against this. I told him to just go buy one. I told him he may cause rust problems or ruin the teneifer finish. What do you think?
-
July 1st, 2006, 11:26 AM #2
I forgot to add he thinks this is a new fad.....NOT!
-
July 1st, 2006, 12:30 PM #3
New fad?
Originally Posted by SSGF109
Now if he wants to start a new fad, tell him some people get those gold plated! Watch him spend more moneySkeet is a sport where you are better to hit half of each bird then completely blast one and miss the other completely.
The choice is yours, place your faith in the court system and 12 of your peers, or carried away by 6 friends.
Nemo Me Impune Lacessit. 'Nobody provokes me with impunity'
ΜOΛΩΝ ΛΑΒΕ
In this world there's two kinds of people, my friend. Those with loaded guns, and those who dig. You dig.
Clint Eastwood
The Good, The Bad and The Ugly
-
July 1st, 2006, 06:02 PM #4
Tenifer is a treatment that penetrates the metal, so even if your friend polishes the barrel the tenifer will still be on the barrel. I am sending my Steyr pistol to Tripp Research to have it hard chromed. Like the Glocks, my Steyr pistols also have the tenifer finish. The hard chrome will add another layer of protection.
Similar Threads
-
Crossbow Question...
By BankerA in forum GeneralReplies: 14Last Post: April 11th, 2014, 03:42 AM -
Does barrel length matter?
By Chunk in forum GeneralReplies: 20Last Post: January 12th, 2010, 10:52 AM -
School/CCW Question.....
By Gary in Pennsylvania in forum GeneralReplies: 38Last Post: August 23rd, 2008, 12:53 AM -
SKS Compliance Question
By JTownPAHunter in forum GeneralReplies: 8Last Post: October 5th, 2007, 10:05 PM
Bookmarks