Results 51 to 60 of 296
Thread: SEPA Milling Party?
-
January 27th, 2020, 11:28 PM #51
-
January 27th, 2020, 11:30 PM #52
-
January 27th, 2020, 11:35 PM #53
-
January 27th, 2020, 11:38 PM #54
-
January 28th, 2020, 01:16 AM #55
Re: SEPA Milling Party?
Depends on the end mill. What size is it? I can probably bring a couple of carbide ones that would last hundreds of lowers, assuming nobody tries to feed it too hard and breaks it.
HSS would be less brittle than carbide, but I doubt we will need to re-sharpen in any reasonable time frame.
-
January 28th, 2020, 10:59 AM #56
-
January 28th, 2020, 11:00 AM #57
-
January 28th, 2020, 11:03 AM #58
Re: SEPA Milling Party?
I was thinking my jig would need replaced after the event. I thought I once read that they're good for 3 lowers in a review.
Maybe I should charge a use fee like Tom Wolf does to replace it at the end of the day.
Exactly what I was thinking.
Since the jig MIGHT be considered a consumable item in this operation...if people chip in $10 to use it, the replacement would probably be mostly covered.
Hope I'm not coming off as an ass, but $135 to use it once myself wouldn't exactly be a deal...and I'd be saving every person $135 from not buying a jig of their own.Last edited by alpacaheat; January 28th, 2020 at 11:12 AM.
Galations 6:9...And let us not grow weary of doing good, for in due season we will reap, if we do not give up.
Ashli Babbitt - Patriot
-
January 28th, 2020, 11:08 AM #59
Re: SEPA Milling Party?
I have this one:
https://www.80percentarms.com/produc...asy-jig-gen-1/
I did NOT buy the bits yet, but here's the sizes required:
https://www.80percentarms.com/produc...-jig-tool-kit/
1) Solid Carbide 1/4 inch end mill - custom made with super short 0.75 in flutes for optimal performance. Made in USA!
1) 3/8 Drill Bit
1) 19/64 drill bit
1) 5/32 drill bit
1) 3/8 drill stop collar
Galations 6:9...And let us not grow weary of doing good, for in due season we will reap, if we do not give up.
Ashli Babbitt - Patriot
-
January 28th, 2020, 11:09 AM #60
Similar Threads
-
Anyone want to have a milling party for their 80% receivers..
By edstephan in forum RiflesReplies: 24Last Post: January 26th, 2020, 04:03 PM -
AR milling jig
By jbraun948 in forum GunsmithingReplies: 0Last Post: March 10th, 2014, 03:32 AM -
Custom milling on my M&P Pro
By garyaug in forum PistolsReplies: 11Last Post: August 28th, 2013, 09:42 PM -
Hk USC/ump milling
By BIRTHMACHINE in forum GeneralReplies: 3Last Post: December 10th, 2009, 09:18 AM
Bookmarks